Replacement Part List

5
PRE-OPERATION INSPECTION
OPERATION
ENGINE OIL: a key factor in deciding the engine’s performance. Do not apply engine oil with additives or
2-stroke gasoline oil, as they haven’t enough lubrication, which may shorten the engine’s service life.
1. Before adding fuel, make sure the engine is on a level, at surface equipment.
Engine oil recommended: SAE10W-30. As viscosity varies
with regions and temperatures, so the Lubricant has to be
selected in accordance with our recommendation.
2. Clean the top of the Dipstick and the area around it. Remove
the Dipstick and wipe it off with a clean, lint free rag.
3. Reinsert the Dipstick without threading it in and remove it to
check the oil level. The oil level should be up to the full level.
4. If the oil level is at or below the low mark add the appropriate
type of oil until the oil level is at the proper level. SAE 10W-30
oil is recommended for general use.
5. Thread the dipstick back in clockwise.
NOTICE: DO NOT run the engine with
too little oil. Engine will shut off if engine
oil level is too low.
OIL IN THE REDUCTION GEAR BOX (only for the model equipped with it) 1/2 Reduction gearbox with an
auto-centrifugal clutch.
1. Before adding fuel, make sure the engine is on a level, at surface. Remove the dipstick and clean it. (Pic.
3. Pic.4)
2. Reinsert the dipstick without screwing it in, and then take out it and check oil level.
3. If the oil level is too low, and recommended engine oil until it arrives the upper level mark. Brand of the oil
is the same as that of engine oil. Oil capacity: 0.50 litres
PIC 3 PIC 4