Replacement Part List

GUIDELINES
8
STOPPING THE ENGINE: Before stopping the engine, keep the engine
idling for 1 to 2 minutes.
1. Release the throttle lever to allow the engine idling for a few minutes.
2. Put the switch to the “O” (Stop) position (F17)
It is recommended to rst practice sawing easy logs. This also helps to get accustomed to your unit.
SAWING:
Always follow the safety regulations. The chainsaw must only be used for cutting wood. It is not
recommended to cut other types of materials.
Do not use the chainsaw as leverage for lifting, moving or splitting objects. Do not lock it over xed
stands.
It is not necessary to force the saw into the cut. Apply only slight pressure while running the engine at
full throttle.
When the chainsaw is caught in the cut, do not attempt to pull it out by force, use a wedge or a lever
to open the way.
GUARD AGAINST KICKBACK: This saw is equipped with a chain brake that will stop the chain
in the event of kickback if operating properly. You must check the chain brake operation properly. You
must check the chain brake operation before each use by running the saw at full throttle for 1 to 2 sec-
onds and pushing the front hand guard forward. The chain should stop immediately with the engine at
full speed. If the chain is slow to stop or does not stop, replace the brake band and clutch drum before
use.
Guide Bar: When the guide bar is dismounted, remove saw dust in the bar groove and the oiling port.
(F26) Grease the nose sprocket from the feeding port on the tip of the bar. (F27)
(1) Oiling Port
(2) Grease Port
(3) Sprocket
Check for fuel leakage and loose fastenings and damage to major
parts, especially handle joints and guide bar mounting. If any defects
are found, make sure to have them repaired before operating again.