Installation Guide

Specifications

Pull out Kitchen Faucet

NOTE: THIS FAUCET IS DESIGNED TO BE

INSTALLED THRU 1 HOLE, Φ1-3/8” MIN.

CRITICAL DIMENSIONS

DESCRIPTION

CARTRIDGE

STANDARDS

• Brass construction

• Flexible supply lines with 3/8” or 9/16”

compression fittings

• Includes Red/Blue indicators

FLOW

• Water usage is limited to these maximum flow rates as

indicated by the corresponding product markings

• North America: 1.8 gpm max (6.8L/min) at 60psi

• California: 1.8 gpm max (6.8L/min) at 60psi

• Ceramic disk cartridge

• Certified to CUPC

• Certified to AB1953

• Certified to NSF/ANSI 61

• ADA for lever handle

WARRANTY

• Lifetime limited warranty against leaks, drips and finish defects

to the original consumer purchaser

• 5 year warranty if used in commercial installations

PAGE 1
Specifications DESCRIPTION • Brass construction • Flexible supply lines with 3/8” or 9/16” compression fittings • Includes Red/Blue indicators FLOW • Water usage is limited to these maximum flow rates as indicated by the corresponding product markings • North America: 1.8 gpm max (6.8L/min) at 60psi • California: 1.8 gpm max (6.8L/min) at 60psi CARTRIDGE Pull out Kitchen Faucet • Ceramic disk cartridge NOTE: THIS FAUCET IS DESIGNED TO BE INSTALLED THRU 1 HOLE, Φ1-3/8” MIN.
PAGE 2
Pull out Kitchen Faucet Installation 2. Install faucet through center hole, re-install rubber and metal washer followed by the lock-nut. Re-install hose connector if 1. Remove locking-nut, metal and removed insuring small rubber washer is rubber washer and hose connector if also installed. Using a screwdriver tighten the lock-nut screws so that the faucet is installed. secure and will not twist. 3.Push pull-out hose in to the hose connector until you hear a click sound. 5.