Operating Manual

ManualsBrandsYaesu Musen ManualsElectronicsHH AMATEUR SCANNING RECEIVER

Basic Operation

FT-70DR/FT-70DE Operating Manual

Transmit mode Description of Modes

MANUAL

Automatically selects one of the 4 communication modes according to the

received signal.

Briefly pressing [PTT] switche between digital mode (DN) and analog FM

mode.

FM FIX

Automatically selects one of the 4 communication modes according to the

received signal.

Always switches to FM mode for transmission.

DN FIX

Automatically selects one of the 4 communication modes according to the

received signal.

Always switches to DN mode for transmission.

VW FIX

Automatically selects one of the 4 communication modes according to the

received signal.

Always switches to VW mode for transmission.

AUTO

Automatically selects one of the 4 communication modes according to the

received signal.

Press [PTT] switch to save the setting and return to normal operation.

●

Changing the communication mode manually

Press the [AMS] key to deactivate the AMS function.

Pressing repeatedly switches the communication mode as follows. Pressing [mode]

key repeatedly switches the communication mode as follows.

[Digital(DN)]→[DigitalWide(VW)]→[Analog(FM)]→

···

Communication Mode Icon Explanation of modes

V/D Mode

(Voice/Data simultaneous

transmission mode)

Calls are less prone to interruptions due to detection

and correction of voice signals during digital voice signal

transmission. This is the standard mode for C4FM Digital.

Voice FR Mode

(Voice Full Rate Mode)

High speed data communication using entire 12.5 kHz

band. Enables high-quality voice communication.

Analog FM Mode

Analog communication using FM mode.

Effective when the signal is weak and audio is susceptible

tointerruption in digital mode.

AM Mode (receive only) AM

The FT-70DR/DE is mainly provides the AM mode for

reception of air band.

In V/D mode (“DN” on the LCD), position information is included in the radio wave during voice

communication, however, position information is not included in the Voice FR mode (“VW” on the

LCD).

ApplicationforFCC/IC

FCCID:K6620515X20,IC:511B-20515X20

Summary of content (10 pages)

PAGE 1
Application for FCC / IC FCC ID: K6620515X20, IC: 511B-20515X20 Basic Operation Transmit mode Description of Modes MANUAL Automatically selects one of the 4 communication modes according to the received signal. Briefly pressing [PTT] switche between digital mode (DN) and analog FM mode. FM FIX Automatically selects one of the 4 communication modes according to the received signal. Always switches to FM mode for transmission.
PAGE 2
Application for FCC / IC FCC ID: K6620515X20, IC: 511B-20515X20 Basic Operation Transmission 1. Press and hold [PTT] switch on the microphone. The Mode/Status Indicator lights up as shown in the table below during transmission. Communication mode Left portion Analog FM V/D mode / Voice FR mode Right portion Red Mode/Status Indicator Red Blue Keep your mouth about 5 cm away from the microphone when you speak. 2. Release [PTT] switch. The transceiver returns to receive mode.
PAGE 3
Application for FCC / IC FCC ID: K6620515X20, IC: 511B-20515X20 Basic Operation Changing the Transmission Power Level The maximum transmit power level of this transceiver is 5 W. When communicating with another station in the immediate area, or to reduce the battery power consumption, the transmit power level may be lowered. 1. ‌Press [F] key, then press the [1](TX PO) key. 2. Rotate the [DIAL] knob to select one of the following transmission power levels.
PAGE 4
Application for FCC / IC FCC ID: K6620515X20, IC: 511B-20515X20 Basic Operation Communicating Via the Repeater The FT-70DR/DE includes an ARS (Automatic Repeater Shift) function which enables repeater operation automatically when setting the receiver to the repeater frequency. ‌ et the receiver frequency to the repeater frequency. 1. S “ ” or “ ” appears in the above of the frequency. 2. Begin transmitting by pressing and holding [PTT] switch.
PAGE 5
Application for FCC / IC FCC ID: K6620515X20, IC: 511B-20515X20 Basic Operation Restoring to Defaults (All Reset) To restore all transceiver settings and memory content to the defaults. When the All Reset function is performed, all data registered in the memory will be deleted. Be sure to note the settings on paper. 1. ‌Turn the radio OFF. 2. Press and hold [MODE] key, [HM/RV] key and [GM] key and turn on the transceiver simultaneously. 3. When the beep sounds, release the key.
PAGE 6
Application for FCC / IC FCC ID: K6620515X20, IC: 511B-20515X20 Specifications ●●General Frequency range: TX 144 - 146 MHz or 144 - 148 MHz 430 - 440 MHz or 430 - 450 MHz RX 108 - 137 MHz (Air Band) 137 - 174 MHz (144 MHz HAM) 174 - 222 MHz (GEN1) 222 - 420 MHz (GEN2) 420 - 470 MHz (430 MHz HAM) 470 - 579.995 MHz (GEN3) Channel steps: 5 / 6.25 / 8.33 / 10 / 12.5 / 15 / 20 / 25 / 50 / 100 kHz (8.33 kHz : only for Air band) Emission Type: F2D, F3E, F7W Frequency stability: ±2.
PAGE 7
Application for FCC / IC FCC ID: K6620515X20, IC: 511B-20515X20 Specifications 0.18 μ V for 12 dB SINAD (400 - 470 MHz, NFM) 1.5 μ V for 12 dB SINAD (470 - 579.995 MHz, NFM) Selectivity (−6dB/−60dB): AF Output: 0.19 μ V TYP for BER 1% (Digital Mode) 12 kHz / 35 kHz (NFM/AM) 700 mW (16 Ω for 10 % THD 7.2 V) internal speaker 300 mW (8 Ω for 10 % THD 7.2 V) external speaker Rated values are at normal temperature and pressure.
PAGE 8
Application for FCC / IC FCC ID: K6620515X20, IC: 511B-20515X20 zz Changes or modifications to this device that are not expressly approved by YAESU MUSEN could void the user’s authorization to operate this device. zz This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference including received, interference that may cause undesired operation.
PAGE 9
Application for FCC / IC FCC ID: K6620515X20, IC: 511B-20515X20 FT-70DR/FT-70DE Operating Manual 29
PAGE 10
Application for FCC / IC FCC ID: K6620515X20, IC: 511B-20515X20 Copyright 2016 YAESU MUSEN CO., LTD. All rights reserved. No portion of this manual may be reproduced without the permission of YAESU MUSEN CO., LTD. YAESU MUSEN CO., LTD. Tennozu Parkside Building 2-5-8 Higashi-Shinagawa, Shinagawa-ku, Tokyo 140-0002 Japan YAESU USA 6125 Phyllis Drive, Cypress, CA 90630, U.S.A. YAESU UK Unit 12, Sun Valley Business Park, Winnall Close Winchester, Hampshire, SO23 0LB, U.K.