Operation Manual

8 FT-817ND Operating Manual
ALKALINE BATTERY INSTALLATION AND USE
The FT-817ND is supplied with the FBA-28 holder for Alkaline “AA” cells. A fresh set of
Alkaline cells should provide approximately 5.5 hours of reception under typical conditions.
1. To install or replace the AA cells, first remove the battery cover from the bottom side of
the transceiver. Slide the battery cover latch forward, as shown in the illustration, then
fold the battery cover upward and set it aside temporarily.
2. Install the Alkaline AA cells as shown in the illustration, paying particular attention to
the correct polarity of the batteries.
3. When all batteries have been successfully installed, replace the battery cover.
INSTALLATION
Important Notes

When the transceiver is to be stored for a long period of time without use (longer
than ten days), remove the batteries from the FBA-28 holder, to avoid the possi-
bility of battery leaking causing damage to the transceiver. Inspect the FBA-28
battery holder occasionally for signs of corrosion or battery leakage, and remove
the batteries immediately if any such damage is observed.

The FBA-28 battery holder is designed for use solely with Alkaline type “AA”
cells. Do not attempt to use Ni-Cd or other rechargeable cells in the FBA-28,
because it does not contain the protection circuitry required when using recharge-
able cells.

When replacing batteries, replace all eight AA cells simultaneously with fresh
batteries.

When the battery voltage is approaching the value which indicates depletion is
near, the small “ ” will blink, indicating it is time to replace the batteries.