Operation Manual

44 FT-817ND Operating Manual
QMB CHANNEL
QMB Channel Storage
1. Tune in the desired frequency and set the operating mode and bandwidth. If this is an
FM channel, set up any required CTCSS/DCS and repeater shift configurations.
2. Press and hold in the key until a double “beep” is heard. The second beep provides
audible confirmation that the data has been stored into the QMB memory.
Pressing the
(
A/B
)
key momentarily while in Operating Function Row 3
[
STO,
RCL, PMS
]
will also store a frequency into the QMB register.
QMB Channel Recall
1. Press the key momentarily, then rotate the knob, as needed, until Operating
Function Row 3
[
STO, RCL, PMS
]
appears on the display.
2. Press the
(
RCL
)
key momentarily to recall the QMB memory. “QMB” will appear
at the upper right corner on the LCD.
3. Press the
(
RCL
)
key once more to return to the previous frequency (either a VFO
frequency or a Memory channel).
If you move the knob or knob while in the QMB mode, you can
change frequencies as if you were in a “VFO” mode. You also can change operat-
ing mode by pressing the or key. When this is done, the “MTQMB”
will appear in the display, where “MT” represents “Memory Tuning.” Press the
(
RCL
)
key once more to return to the originally-stored QMB frequency.
MEMORY OPERATION