Operation Manual
59FT-817ND Operating Manual
MENU OPERATION
1: Depends on transceiver version.
2: Depends on operating band and transceiver version.
Menu Item Function Available Values Default
19 CW PADDLE Select the keyer paddle's wiring configuration
NORMAL/REVERSE
NORMAL
20 CW PITCH Setting of the pitch of the CW sidetone, BFO offset, 300 ~ 1000 Hz 700 Hz
and CW filter center frequencies
21 CW SPEED Set the sending speed for the built-in Electronic keyer 4wpm ~ 60 wpm/ 12 wpm
20cpm ~ 300 cpm (60 cpm)
22 CW WEIGHT Set the Dot:Dash ratio for the built-in electronic keyer 1:2.5 ~ 1:4.5 1:3.0
23 DCS CODE Setting the DCS code 104 Std DCS codes 023
24 DIG DISP Define the displayed frequency offset -3000 ~ +3000 Hz 0 Hz
during DIG (USER-L or USER-U) mode operation
25 DIG MIC Adjust the audio input level from terminal equipment 0 ~ 100 50
(such as a TNC or PSK-31 sound card)
during DIG (Digital) mode operation
26 DIG MODE Select the mode and sideband (if applicable) RTTY/ RTTY
in the DIG (Digital) mode PSK31-L/PSK31-U/
USER-L/USER-U
27 DIG SHIFT Define the carrier frequency offset -3000 ~ +3000 Hz 0 Hz
during DIG (USER-L or USER-U) mode operation
28 EMERGENCY
Enable Tx/Rx operation on the Alaska Emergency Channel,
OFF/ON OFF
5167.5 kHz (USA Version only)
29 FM MIC Adjust the microphone gain level for the FM mode 0 ~ 100 50
30 FM STEP Select the tuning steps for the
knob 5/6.25/10/12.5/15/ 2
on the FM mode 20/25/50 kHz
31 ID Store your callsign into the CW identifier – YAESU
32 LOCK MODE Select the operation of the front panel’s key DIAL/FREQ/PANEL DIAL
33 MAIN STEP Setting of the ’s tuning speed FINE/COARSE FINE
34 MEM GROUP Enable/disable the memory grouping feature OFF/ON OFF
35 MEM TAG Store Alpha-Numeric “Tags” for the memory channels – –
36 MIC KEY Enable/disable CW keying OFF/ON OFF
by the microphone’s
[
UP
]
/
[
DWN
]
keys
37 MIC SCAN Enable/disable scanning access OFF/ON ON
38 OP FILTER Enable the optional filter (CW or SSB) OFF/SSB/CW OFF
39 PKT MIC Adjust the audio input level from the TNC 0 ~ 100 50
during 1200 bps Packet operation
40 PKT RATE Set the transceiver’s circuitry for the Packet baud rate 1200/9600 bps 1200 bps
41 RESUME Set the delay time for scanning resumption OFF/3/5/10 seconds 5 sec
42 RPT SHIFT Set the magnitude of the Repeater Shift 0 ~ 99.99 MHz 2
43 SCOPE Select the Spectrum Scope mode CONT/CHK CONT
44 SIDETONE Adjust the CW sidetone volume level 0 ~ 100 50
45 SQL/RF-G
Select the configuration of the front panel’s knob
RF-GAIN/SQL 1
46 SSB MIC Adjust the microphone gain level for the SSB mode 0 ~ 100 50
47 SSB STEP
Select the tuning steps for the knob on the SSB mode
1/2.5/5 kHz 2.5 kHz
48 TONE FREQ Setting the CTCSS Tone Frequency 50 Std CTCSS tones 88.5 Hz
49 TOT TIME Select the Time-Out-Timer time OFF/1 ~ 20 min OFF
50 VOX DELAY Set the “hang time” for the VOX circuitry 100 ~ 2500 msec 500 msec
51 VOX GAIN Set the gain of the VOX circuitry's input audio detector 1 ~ 100 50
52 EXTEND Enable/disable the extended Menu Items (#53 ~ #57) OFF/ON OFF
53 DCS INV Select “Normal” or “Inverted” DCS coding Tn-Rn/Tn-Riv/ Tn-Rn
Tiv-Rn/Tiv-Riv
54 R LSB CAR Set the Rx Carrier Point for LSB -300 ~ +300 Hz 0 Hz
55 R USB CAR Set the Rx Carrier Point for USB -300 ~ +300 Hz 0 Hz
56 T LSB CAR Set the Tx Carrier Point for LSB -300 ~ +300 Hz 0 Hz
57 T USB CAR Set the Tx Carrier Point for USB -300 ~ +300 Hz 0 Hz