User Manual

ManualsBrandsYale ManualsOutdoor ContactYale AC-ODC Outdoor Contact

Outdoor Contact

ACODC

ACODC is an Outdoor Contact used to detect the opening and closure of

outdoor gates, entries, exits and more. The Outdoor Contact can also be

placed on metal materials, while its powerful magnet can tolerate a wide gap

to reduce false alarm.

The device also has the capabilities of communicating signal problems along

with low battery situations. The front and back tamper switches provide

tamper protection against unauthorised device opening and removal.

Summary of content (6 pages)

PAGE 1
Outdoor Contact AC-ODC AC-ODC is an Outdoor Contact used to detect the opening and closure of outdoor gates, entries, exits and more. The Outdoor Contact can also be placed on metal materials, while its powerful magnet can tolerate a wide gap to reduce false alarm. The device also has the capabilities of communicating signal problems along with low battery situations. The front and back tamper switches provide tamper protection against unauthorised device opening and removal.
PAGE 2
Outdoor Contact Front View Inside View 6 5 Magnet Back View Mounting Bracket Front View Mounting Bracket 11 7 8 9 10 10 1. Protective Cover 2. Battery Cover 3. Front Tamper Switch. When the battery cover is removed, the front tamper switch will be activated. 4. LED indicator 5. Learn / Test button Use a sharp tool to press the button to transmit learning code or enter test mode for 3 min. 6. Battery Compartment The Outdoor Contact uses two AA L91 Lithium batteries as its power source.
PAGE 3
LED Indicator • In Normal Operation Mode, the LED will not light when the Outdoor Contact is activated. • When the Outdoor Contact battery voltage is low, every time the Outdoor Contact is activated (device opened/ closed), the LED will flash. • When any of the tamper switches is triggered, the LED will flash. When a tamper condition persists, the LED will flash whenever the Outdoor Contact is activated. • When the Outdoor Contact is in Test mode, the LED will flash every time it is activated.
PAGE 4
Getting Started • Use a flat-head screwdriver into the slot and push upward to open the protective cover. (Figure 1) • Remove the battery cover and insert batteries to power on the device. • Put the Sync hub into Learning Mode (please refer to panel operation manual). • Use a sharp tool to press the Outdoor Contact learn button. • Refer to your Sync hub operation manual to complete the learn-in process.
PAGE 5
NOTE Make sure the back tamper switch of the Outdoor Contact is pressed against the break-away area on the mounting bracket. 5) Secure the bottom fixing screw. 6) Replace the protective cover. 7) Mount the magnet bracket with two supplied screws to the door, attach the magnet to the magnet bracket. NOTE The magnet and Outdoor Contact rib marks must align. 8) Installation is now complete.
PAGE 6
www.yalehome.co.