Owner`s manual

4-17
E
602053
EMU00396
Installing the Propeller
cC
8 Be sure to install the thrust washer
before installing the propeller, other-
wise the lower case and propeller boss
may be damaged.
8 Be sure to use a new cotter pin and
bend the ends over securely. Otherwise
the propeller could come off during
operation and be lost.
1) Apply Yamaha Marine grease or a
corrosion resistant grease to the pro-
peller-shaft.
2) Install the thrust washer and propeller
on the propeller-shaft.
3) Install the washer and tighten the pro-
peller nut to the specified torque.
4) Align the propeller nut with the pro-
peller shaft hole. Insert a new cotter
pin in the hole and bend the cotter pin
ends.
NOTE:
When the propeller nut does not align
with the propeller shaft hole after tighten-
ing to the specified torque, then tighten
the nut further to align it with the hole.
Tightening torque:
Refer to “SPECIFICATIONS” page 4-1.
6M8-F9-17-4 2/4/03 9:50 AM Page 18