0 Manual

Connections
Connecting the FM and AM
antennas
Both FM and AM indoor antennas are supplied with this
unit. In general, these antennas should provide sufficient
signal strength. Connect each antenna correctly to the
designated terminals.
Notes
Assembling the supplied AM loop antenna
The AM loop antenna should be placed away from this unit.
A properly installed outdoor antenna provides clearer reception
than an indoor one. If you experience poor reception quality,
install an outdoor antenna. Consult the nearest authorized
Yamaha dealer or service center about outdoor antennas.
The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
AM loop
antenna
(supplied)
Indoor FM
antenna
(supplied)
Ground
For maximum safety and minimum
inlcrrcrcncc. connect the anlcnna GND
terminal io a good carlh ground. A good earth
ground is a metal stake driven inlo moist earth.
Note
The types of the supplied AM loop antenna is different
depending on the models.
Connecting the power cable
Once all connections are complete, plug the power cable
into the AC wall outlet.
■ Power cable
(U.S.A. model)
To the AC wall outlet
Turning on and off the power
I Turning on this unit
Connecting the wire of the AM loop antenna
The wire of the AM loop antenna does not have any polarity
and you can connect either end of the wire to AM or GND
terminal.
Press ® STANDBY/ON (or ® POWER) to turn
on this unit.
When you turn on this unit, there will be a 4 to 5-second delay
before this unit can reproduce sound.
■ Set this unit to the standby mode
Press ®STANDBY/ON (or ® STANDBY) to set
this unit to the standby mode.
Note
In the Standby mode, this unit consumes a small amount of power
in order to receive infrared signals from the remote control.
19 En