0 Manual

Playback
■ Selecting audio input jacks
(AUDIO SELECT)
This unit comes with a variety of input jacks. Use this
feature (audio input jack select) to switch the input jack
assigned to an input source when more than one jacks are
assigned to an input source.
• We recommend setting audio input jack select to “AUTO” in
most ca,ses.
• You can adjust the default audio input jack select of this unit by
using “AUDIO SELECT” in “OPTION MENU” (see page 50).
Press (o)AUDIO SELECT (or press 0AMP and
then ©AUDIO SEL) repeatedly to select the
desired Audio input jack select setting.
V-AUX DTtf/CBL ►DVD MO/CD-R TUUER CD
Audio input jack seiect setting
Automatically selects input signals in the
following order:
(1) Digital signals
(2) Analog signals
Selects only analog signals. If no analog
signals are input, no sound is output.
Note
This feature is not available when no digital input jack are
assigned to the currently selected input source.
■ Selecting the night listening mode
The night listening modes are designed to improve
listenability at lower volumes or at night.
1 Press 0AMP and then press ©NIGHT
repeatedly to select “NIGHTiCINEMA” or
“NIGHTiMUSIC”.
Choices: NIGHT:CINEMA, NIGHT:MUSIC,
NIGHT OFF
• Select “NIGHT:CINEMA” to reduce the dynamic
range of film soundtracks and make dialog easier to
hear at lower volumes.
• Select “NIGHT:MUSIC” to preserve
ease-of-listening for all sounds.
• Select “NIGHT OFF” if you do not want to use this
feature.
Press ©<l /o to adjust the effect level while
“NIGHTiCINEMA” or “NIGHTiMUSIC” is
displayed in the front panel display.
Choices: MIN, MID, MAX
• Select “MIN” for minimum compression.
• Select “MID” for standard compression.
• Select “MAX” for maximum compression.
“NIGHT:CINEMA” and “NIGHT:MUSIC” adjustment.s are
stored independently.
Notes
• You cannot use the night listening modes in the following cases:
- when the component connected to the MULTI CH INPUT
jacks is selected as the input source.
- when headphones are connected to the PHONES jack.
- when the sampling frequency of the input sources are higher
than 96 kHz.
• The night listening modes may vary in effectiveness depending
on the input source and surround sound settings you use.
■ Adjusting the tonal quality
Use this feature to adjust the balance of bass and treble for
the front left and right speaker channels.
Press ©TONE CONTROL repeatedly to select
“BASS” or “TREBLE” and then press
©PROGRAM <1/0 to adjust the corresponding
frequency response level.
Control range: -10 to +10 dB
Control step: 2
• Select “BASS” to adjust the low-frequency response.
• Select “TREBFE” to adjust the high-frequency
response.
Notes
Speaker and headphone adjustment.s are stored independently.
If you increase or decrease the high-frequency or low-frequency
sound to an extreme level, the tonal quality of the surround
speakers may not match that of the front left and right speakers.
When a night listening mode is selected, the NIGHT
indicator light.s up in the front panel display.
31 En