0 Manual

Troubleshooting
■ iPod
Note
In case of a transmission
page 18).
error without a status message appearing in the front panel display, check the connection to your iPod (see
Stntus messnge Cause Remedy
See
page
Connect ennon
There is a problem with the signal path
from your iPod to this unit.
Turn off this unit and reconnect the Yamaha iPod
universal dock to the DOCK terminal of this unit.
18
Try resetting your iPod.
—
UnlonOWn Ih'Od
The iPod being used is not supported by
this unit.
Only iPod (Click and Wheel), iPod nano, and iPod
mini are supported.
—
iF'od connected
Your iPod is properly stationed in a
Yamaha iPod universal dock (such as
YDS-10, sold separately) connected to the
DOCK terminal of this unit, and the
connection between your iPod and this
unit is complete.
Your iPod was removed from a Yamaha
iPod universal dock (such as YDS-10,
sold separately) connected to the DOCK
terminal of this unit.
Station your iPod back in a Yamaha iPod universal
dock (such as YDS-10, sold separately) connected to
the DOCK terminal of this unit.
18
■ Bluetooth
Stiitus message Cause Remedy
See
page
:::::en=ir''C.r'!:i. rV:::i .............
The HlucU'Dili adaplcf aiul llic P>lucUHiih
component is in the middle of the pairing.
The Bluetooth adapter and the Bluetooth
component is in the middle of establishing
the connection.
Conp1eted
The paring is completed.
iJance 1 ed
The paring is canceled.
D! conneciec!
The connection between the Yamaha
Bluetooth adapter (such as YBA-10, sold
separately) and the Bluetooth component
is established.
D i sconnected
The Bluetooth component is disconnected
from the Bluetooth adapter (such as
YBA-10, sold separately).
\
No BT adapten
The Bluetooth adapter is not connected to
the DOCK terminal.
Connect the Yamaha Bluetooth adapter (such as
YBA-10, sold separately) to the DOCK terminal.
18
58 En