User`s guide

Sun SPARC Enterprise M8000/M9000 Servers Product Notes 5
General Functionality Issues and Limitations
Caution For dynamic reconfiguration (DR) and hot-plug issues, see “Solaris OS
Issues and Workarounds” on page 8.
Note For power-on after power-off, wait at least 30 seconds before turning the
system power back on, by using the main line switch or the circuit breakers on the
distribution panel.
DR and XSCF failover are not compatible. Do not start an XSCF failover while a
DR operation is running. Wait for a DR operation to finish before starting the
failover. If you start the failover first, wait for the failover to finish before starting
the DR operation.
For 1027A-Z/X1027A-Z, PCIe Dual 10 Gigabit Ethernet Fiber XFP cards, these
limits apply:
Do not use more than two cards per domain.
Do not use these cards in an External I/O Expansion Unit.
For 4447A-Z/X4447A-Z, PCIe Quad-port Gigabit Ethernet Adapter UTP cards,
these maximum limits apply:
No more than four cards in an External I/O Expansion Unit (two per PCIe I/O
boat).
No more than eight cards in a domain.
Do not install more than six IOUA cards per domain in a SPARC Enterprise
M8000/M9000 server if you are using a version of Solaris earlier than Solaris 10
5/08. ]
To complete updating the OpenBoot™ PROM firmware in the target domain, be
sure to power off/on the domain.
When the Solaris OS is in single user mode, do not switch from the domain
console to the XSCF Shell as the Solaris OS might switch to multi-user mode.
Do not use the CD-RW/DVD-RW drive unit and the TAPE drive unit at the same
time.
The XSCF browser interface (XSCF Web), does not support the External I/O
Expansion Unit Manager feature.
The use of the External I/O Expansion Unit to connect the host server to an
external boot disk drive is not supported.
You cannot use the following user account names, as they are reserved by the
XSCF firmware for system use: adm, admin, apache, bin, daemon, default,
ldap, nobody, ntp, operator, root, rpc, rpcuser, and sshd.