User`s guide

14 SPARC Enterprise M8000/M9000 Servers Product Notes for XCP 1070 • April 2008
6559504 Messages of the form nxge: NOTICE:
nxge_ipp_eccue_valid_check: rd_ptr
= nnn wr_ptr = nnn will be observed on
the console with the following cards:
• X4447A-Z, PCI-e Quad-port Gigabit Ethernet
Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
These messages can be safely ignored.
6563785 Hot-plug operation with the following cards
might fail if a card is disconnected and then
immediately reconnected:
• SG-XPCIE2SCSIU320Z Sun StorageTek
PCI-E Dual-Port Ultra320 SCSI HBA
• SGXPCI2SCSILM320-Z Sun StorageTek
PCI Dual-Port Ultra320 SCSI HBA
After disconnecting a card, wait for a few
seconds before re-connecting.
6564934 Performing a DR deleteboard operation on
a board which includes Permanent Memory
when using the following network cards
results in broken connections:
• X4447A-Z, PCI-e Quad-port Gigabit Ethernet
Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
Reconfigure the affected network interfaces
after the completion of the DR operation. For
basic network configuration procedures, refer to
the ifconfig man page for more information.
6568417 After a successful CPU DR deleteboard
operation, the system panics when the
following network interfaces are in use:
• X4447A-Z, PCI-e Quad-port Gigabit Ethernet
Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
Add the following line to /etc/system and
reboot the system:
set ip:ip_soft_rings_cnt=0
6571370 Use of the following cards have been
observed to cause data corruption in stress
test under laboratory conditions:
• X4447A-Z, PCI-e Quad-port Gigabit Ethernet
Adapter UTP
• X1027A-Z1, PCI-e Dual 10 Gigabit Ethernet
Fiber XFP Low profile Adapter
Add the following line in /etc/system and
reboot the system:
set nxge:nxge_rx_threshold_hi=0
TABLE 6 Solaris OS Issues and Workarounds Fixed in Solaris 10 5/08 (3 of 4)
CR ID Description Workaround