User`s guide

Sun SPARC Enterprise M8000/M9000 Servers Product Notes 21
2. Configure the ISN network.
XCP 1050 or later supports dual XSCF configuration. The Inter-SCF Network
provides an internal communication link between the two XSCF Units (active and
standby).
If you do not explicitly set the IP addresses on the ISN network, XCP will use the
following default values:
In case the IP address of XSCF-LAN or DSCP conflicts with the default subnet
address of ISN, it is necessary to specify the IP address of ISN. The following is an
example.
3. Delete any accounts named admin.
Use the showuser -lu command to list all XSCF accounts. Any accounts named
admin must be deleted prior to upgrading to XCP 1070. The admin account
name is reserved. Use the deleteuser command to delete the account.
Note – For more information on admin accounts, see TABLE 9, “Software
Documentation Updates” on page 17.
▼ To Upgrade From XCP 1041 or Lower
Note – Do not access the XSCF units via the “Takeover IP address.”
Note – LAN connections are disconnected when the XSCF resets. Use the XSCF
serial connection to simplify the XCP upgrade procedure.
The XSCF will be reset. Continue? [y|n] :n
XSCF> setroute -c del -n 0.0.0.0 -m 0.0.0.0 -g 100.200.300.2 lan#0
XSCF> setroute -c del -n 0.0.0.0 -m 0.0.0.0 -g 100.200.300.1 lan#0
XSCF> applynetwork -y
xscf#0-if: 192.168.1.1
xscf#1-if: 192.168.1.2
XSCF>setnetwork xscf#0-if -m 255.255.255.0 192.168.12.11
XSCF>setnetwork xscf#1-if -m 255.255.255.0 192.168.12.12
XSCF>applynetwork