User`s guide

Sun SPARC Enterprise M8000/M9000 Servers Product Notes 23
Caution – The flashupdate command will update one bank, reset the XSCF, and
commence update of the second bank. Before proceeding to Step 9, you must verify
that the current and reserve banks are both updated. If both banks indicate XCP
revision 1070, proceed to the next step.
9. Confirm completion of the update.
Confirm no abnormality happens while updating XCSF_B#0.
10. Confirm that both the current and reserve banks of XSCFU#0 display the
updated XCP versions.
If the Current and Reserve banks on XSCF#0 do not indicate XCP revision 1070,
contact your authorized service representative.
11. Confirm the servicetag(8) facility is enabled.
a. Check the servicetag facility status by using the showservicetag(8)
command.
b. If it is currently disabled, you must enable it.
c. Reboot the XSCF to enable the servicetag facility.
XSCF> showlogs event
XSCF>
version -c xcp
XSCF#0 (Active )
XCP0 (Reserve): 1070
XCP1 (Current): 1070
XSCF#1 (Standby)
XCP0 (Reserve): 0000
XCP1 (Current): 0000
XSCF> showservicetag
Disabled
XSCF> setservicetag -c enable
Settings will take effect the next time the XSCF is rebooted.