Instructions / Assembly

Plastic Sheet
Muffler
MUFFLER (YS2565 / YS2865 ONLY)
1. Remove the cap of the manual tube. Align the holes in the
manual tube with the holes in the tow bar, insert and tighten
bolts and washers. (See Figure 11)
2. Reattach the cap.
1. Remove the plastic sheet by loosening and removing the nuts
and washers, using a 13mm wrench.
2. Install the mufer by aligning the screw holes on the mufer to
the screw holes on the engine. Reinstall the washer and nuts,
using a 13mm wrench.
MANUAL TUBE
M8x20 (x2)
Manual Tube
Cap
Align the left fender to the tank assembly. Insert the M8x20 bolts,
spring washers, at washers, and tighten by using a 13mm wrench.
(See Figure 10)
Follow the same procedure to assemble the right fender.
M8x20 (x8)
Fender (Left)
Tank Assembly
FENDER
VERTICAL POSITION TO HORIZONTAL POSITION
1. Remove the bridge pin and lock pin from the lower hole.
2. Hold the hydraulic cylinder handle and slowly lower the beam.
Insert the lock pin into the upper hole. Make sure the beam is
locked in the horizontal position.
3. Attach the bridge pin in the lock pin.
M12x35 (x8)
Inside Holes
Outside Holes
Log Cradle (Left)
1. Align the holes on the left log cradle to the inside and lower holes
on the beam mounts. Insert the M12x35 bolts, at washers, nuts
and securely tighten.
2. Follow step 1 to assemble the right log cradle. (See Figure 14)
LOG CRADLES
Place the work table over the holes in the log cradle and align
the 4 holes from the work table plate and log cradle. Insert
and tighten the M10x25 bolts, spring washers, at washers,
and nuts.
LOG TABLE (OPTIONAL)
Log Cradle (Right)
Outside
Holes
Inside
Holes
M10x25 (x4)
Work Table
Refer to Figures 15a and 15b to install the work table. Remove
the bolts, at washers, and nuts from the inside holes. Move
the log cradle from the incline position to the horizontal
position. Align holes on the log cradle with the outside holes
on the beam mount. Reinstall bolts, at washers, and nuts.
1 2
1
2
Hydraulic Cylinder Handle
Lower Hole
Upper Hole
Upper Hole
1 2
1
2
Hydraulic Cylinder Handle
Lower Hole
Upper Hole
Upper Hole
M8 X 20 X 8
9
M8 X 20 X 2
10
M12 X 35 X 8
11
M10 X 25 X 4
12
16 mm
13 mm
18 mm
19 mm
16 mm
13 mm
18 mm
19 mm
32 mm
13 mm
16 mm
19 mm
16 mm
13 mm
18 mm
19 mm
32 mm
13 mm
16 mm
19 mm
16 mm
13 mm
18 mm
19 mm
16 mm
13 mm
18 mm
19 mm
16 mm
13 mm
18 mm
19 mm
32 mm
13 mm
16 mm
19 mm
Do not let the beam suddenly drop. Keep hands and
ngers clear of pinch or crush points at all times.
17 18
Gas Log Splitter
»
Operator’s Manual
Assembly
||
Assembly
Figure 15b
Figure 15a
Figure 14
Figure 13b
Figure 13a
Figure 12a
Figure 11
Figure 10
Figure 12b