Instructions / Assembly
Your YARDMAX log splitter comes partially assembled and contains the following:
CONTENTS SUPPLIED
OPTIONAL
Handware Kit
4
9
10
3
2
15
125
11
16
6
7
13
14
8
1
1. Beam and Reservoir with Engine
2. Fender (Left)
3. Fender (Right)
4. Wheel Axle
5. Wheels
6. Manual Tube
7. Tow Bar
8. Log Stripper
9. Log Cradle (Left)
10. Log Cradle (Right)
11. Beam Lock Bracket
12. Mufer (YS2565 and YS2865 only)
13. Operator’s Manual and Engine Manual
14. Tools for Spark Plug Assembly (YS2565 and YS2865 only)
15. Log Table (Optional)
16. Hardware Kit, Including:
18 X 135 X 1
1
Bridge Pin X 1
M10 X 35 X 6
2
YS2565
YS2865
YS3065
M10 X 35 X 4
2
YS3067
M10 X 20 X 2
M12 X 80 X 2
3
M22 X 1
4
4 X 50 X 1
X 1
M12 X 30 X 4
5
M22 X 1
6
4 X 50 X 1
X 1
M10 X 25 X 2
7
M12 X 80 X 1
8
12 X 80 X 1
M8 X 20 X 8
9
M8 X 20 X 2
10
M12 X 35 X 8
11
M10 X 25 X 4
12
OPTIONAL
This log splitter was partially assembled at the factory. To assemble your machine follow the below instructions.
ASSEMBLY
BEAM PIVOT BRACKET
1. Slowly pull the beam in a straight line until the pivot casing in
the tank pivot mount is locked by the U-shaped bracket in the
beam. Then make sure the hole in the beam pivot bracket aligns
with the pivot hole in the tank pivot mount. (See Figure 2a.)
3. Disassemble the support leg from the unit. (Remove the bolts
and nuts, see Figure 2b.)
2. Insert the pivot bolt and secure with the bridge pin.
SPLIT CONTROL LEVER
1. Holding the hydraulic cylinder handle, pull out the cylinder
slowly and in a straight line until the output shaft in the
cylinder is against the trunnion mount and locked in the
U-shaped groove.
2. The control handle is shipped hanging from the valve on the
handle link. Remove the pin and cotter pin from the control
handle. Move the control lever to the vertical Neutral positon
(shown in circle on illustration Figure 3.)
3. Reinstall the pin and cotter pin to the control handle.
Loosen two M10 nuts by using a 16mm wrench. Change the handle
from the vertical position to the horizontal position. Secure and
tighten the two M10 nuts. (See Figure 4)
HYDRAULIC CYLINDER HANDLE
Hydraulic Cylinder Handle
Vertical Position
Horizontal Position
2"
Pivot Bolt
U-Shaped Bracket
Pivot Hole
Bridge Pin
Trunnion Mount
Pin
Cotter Pin
Hydraulic Cylinder Handle
Output Shaft
If beam is pulled left or to the right, this could cause
instability of the product and could result in injury.
18 X 135 X 1
1
Bridge Pin X 1
16 mm
13 mm
18 mm
19 mm
16 mm
13 mm
18 mm
19 mm
X 2
11 12
Gas Log Splitter
»
Operator’s Manual
Assembly
||
Contents Supplied
Figure 4
Figure 3
Figure 2b
Figure 2a