Replacement Part List

TROU
BL
ESHOOTI
N
G
PARTS DIAGRAM
* Parts List on page 34
Cause Remedy
1. Air in the hydraulic oil system
2. Debris lodged in beam guides
ow h
ydraulic oil
1. Purge air by extending and retracting
the wedge several times until motion is
smooth
2. Clear debris from beam
3. Check oil level and add as needed
1. Faulty cylinder rod seal
2. Scored or bent cylinder rod
Faulty combination washer seal on
1. Contact customer service
2. Contact customer service
4. Contact customer service
1. Faulty control valve
2. Faulty hydraulic pump
ow h
ydraulic oil
1. Contact customer service
2. Contact customer service
3. Check oil level and add as needed
ow h
ydraulic oil
2. Faulty control valve
1. Check oil level and add as needed
2. Contact customer service
1. Hydraulic oil too cold
2. Hydraulic oil too thick
3. Hydraulic oil contaminated
4. Faulty control valve
1. Warm up engine
4. Contact customer service
1. Engine switch in OFF position
4. Spark plug disconnected
6. Choke lever in wrong position
7. Faulty engine
1. Move switch to ON position
2. Move valve to ON position
3. Fill fuel tank with fuel
4. Connect spark plug
5. Replace spark plug
6. Adjust choke lever position
7. Contact customer service

Summary of content (4 pages)