Save This Manual for Future Reference Gas Log Splitter Operator’s Manual MODEL NUMBER YS2565 YS2865 YS3065 YS3567 SERIAL NUMBER PURCHASE DATE Both model number and serial number may be found on the main label. You should record both of them in a safe place for future use.
Gas Log Splitter Your new YARDMAX™ gas log splitter offers quality construction, and is easy and safe to operate. With proper use and care, it is designed to give you many years of dependable service.
Gas Log Splitter » Operator’s Manual support Have questions about your YARDMAX equipment? Call us at 844-YARDMAX, email us at support@yardmax.com, or contact us via your favorite social media site. Model # YS2565 YS2865 YS3065 YS3567 Pump Size 14 GPM 14 GPM 17 GPM 17 GPM 4" 4.5" 4.5" 5" Hydraulic Cylinder Stroke 23.5" 23.5" 23.5" 23.5" Hydraulic Rod Diameter 1.75" 1.75" 1.75" 2" 9.7 seconds 13.2 seconds 10.9 seconds 12.8 seconds 4.0 Gallon 4.3 Gallon 4.3 Gallon 4.
Gas Log Splitter Symbols Read these instructions carefully. Wear eye protection. Keep hands away from moving parts. Moving parts can crush or cut. Wear hearing protection. Keep feet away from moving parts. Moving parts can crush or cut. Wear protective gloves. Always keep body and hands away from pin holes or nozzles that eject hydraulic fluid under pressure. Escaping hydraulic fluid can puncture skin and cause blood poisoning. Wear safety footwear.
Gas Log Splitter ENGINE SAFETY This machine is equipped with an internal combustion engine. Do not use on or near any unimproved, forest covered, or brush covered land unless the exhaust system is equipped with a spark arrester meeting applicable local, state, or federal laws. In the state of California, a spark arrester is required by law. Other states have similar laws. A spark arrester, if used, must be maintained in effective working order by the operator.
Gas Log Splitter » Operator’s Manual UNPACKING THE CONTAINER TOWING SAFETY Check all local and state regulations regarding towing, licensing, and lights before towing your log splitter. Before towing the log splitter, check tires for excessive wear, cuts, or damage. Check for proper tire inflation. Add air as required. Do not over inflate tires. Serious injury can result if tires explode.
Gas Log Splitter » Operator’s Manual CONTENTS SUPPLIED ASSEMBLY Your YARDMAX log splitter comes partially assembled and contains the following: This log splitter was partially assembled at the factory. To assemble your machine follow the below instructions. 2 8 3 9 4 10 1 BEAM PIVOT BRACKET SPLIT CONTROL LEVER 1. S lowly pull the beam in a straight line until the pivot casing in the tank pivot mount is locked by the U-shaped bracket in the beam.
19 mm Gas Log Splitter » Operator’s Manual 18 mm LOG STRIPPER (YS2565, YS2865, and YS3065 ONLY) TOW BAR 1. A lign holes in the log stripper with the holes in the trunnion mount. Insert the tow bar into the tank bracket and align the holes. Connect and tighten the tow bar to the tank by using the M12x80 bolts, flat washers, spring washers, and nuts. (See Figure 6) 2. I nstall the log stripper by tightening the M10x35 bolts, spring 19 mm and flat washers.
Gas Log Splitter » Operator’s Manual 19 mm 14. Move the bridge pin and lock pin from the upper hole to the lower hole. Make sure the bridge pin is connected to the wire rope first and then insert the lock pin. (See Figure 7g) 1 16. Rotate the bottom pallet slowly until there is enough space to assemble the other wheel. 18. Follow the same procedure to assemble the other wheel. (Follow 16 mm steps 3 – 10 under wheel assembly.) Lock Pin Lower Hole 32 mm 3.
Lower Hole Gas Log Splitter 19 mm » Operator’s Manual 19 mm 18 mm FENDER 16 mm MUFFLER (YS2565 / YS2865 ONLY) Align the left fender to the tank assembly. Insert the M8x20 bolts, spring washers, flat washers, and tighten by using a 13mm wrench. (See Figure 10) 1. R emove the plastic sheet by loosening and removing the nuts and washers, using a 13mm wrench. 16 mm Follow 32the mm same procedure to assemble the right fender.
Gas Log Splitter » Operator’s Manual KNOW YOUR MACHINE FEATURES AND CONTROLS Log Table (Optional) Log Spinner Foot Plate Engine On/Off Switch 2-Position Log Cradle Recoil Starter Handle Split Control Handle Throttle Control 4-Way Wedge Choke Control Log Stripper Fuel Shut-Off Valve Cylinder Hydraulic Cylinder Handle LOG SPINNER FOOT PLATE Manual Tube Beam Assembly The foot plate holds the log in place while the wedge splits the log.
Gas Log Splitter CHOKE CONTROL RECOIL STARTER HANDLE The choke control is used to choke the carburetor and assist in starting the engine. The choke control slides The handle is used to start the engine. between the CHOKE CLOSED positions. FUEL SHUT-OFF VALVE The fuel shut – off has two position. CLOSED ( ) - use this position to service, transport, or store the unit. OPEN ( STOP ENGINE 1. Make sure the control lever is in the neutral position.
Gas Log Splitter » Operator’s Manual TRANSPORTING CONVERSION BETWEEN HORIZONTAL SPLITTING POSITION AND VERTICAL SPLITTING POSITION Neutral Position Reverse Position Forward Position MOVING BY HANDS 3. Make sure hitch is in good working order. The log splitter is heavy. It can crush and cause serious injury if it rolls out of control or tips over. 4. C heck safety chains. Two safety chains must be used while towing.
Gas Log Splitter MAINTENANCE Inspect and maintain the log splitter before each use. If the log splitter has been used previously, it must be inspected and maintained before each subsequent use. Always shut off the engine and relieve system pressure before inspecting, cleaning, adjusting, or repairing the splitter. Relieve system pressure by moving the split control lever back and forth several times. Remove debris from the engine, muffler, and moving parts. Debris on a hot engine can be a fire hazard.
Gas Log Splitter TROUBLESHOOTING Problem Wedge movement is slow or erratic Cause Operator’s Manual PARTS DIAGRAM Remedy 2. Debris lodged in beam guides 1. P urge air by extending and retracting the wedge several times until motion is smooth 3. Low hydraulic oil 2. Clear debris from beam 1. Air in the hydraulic oil system » 3. Check oil level and add as needed 1. Faulty cylinder rod seal 2. Scored or bent cylinder rod Oil leak from cylinder 3. Loose hydraulic fitting 4.
Gas Log Splitter » Operator’s Manual YS2565/YS2865 PARTS LIST No. Description Qty No. Description Qty No.
Gas Log Splitter » Operator’s Manual YS3065 PARTS LIST No. Description Qty No. Description Qty No.
Gas Log Splitter YS3567 PARTS LIST No. Description Qty No. Description Qty No. Description Qty 1 37 Half Round Key 1 73 Tire 2 No.
yardmax.com Tame the Great Outdoors TM 1850 W Winchester Rd, Suite 106 | Libertyville, IL 60048 | 844-YARDMAX (844-927-3629) | info@yardmax.
