Full Product Manual

Figure 9
OPERATION
1. Make sure the front tine tiller is on a at, level surface.
ADD OIL TO ENGINE
3. Using a funnel, add oil up to the FULL mark on the dipstick.
(See engine manual for oil capacity, oil recommendation, and
location of ll cap.)
The engine is shipped without oil. Do not start the
engine before adding oil. Refer to your engine manual
for the proper oil gauge to use.
Gasoline is highly ammable and explosive. You can
be burned or seriously injured when handling fuel.
Use extreme care when handling gasoline.
Fill the fuel tank outdoors, never indoors. Gasoline
vapors can ignite if they collect inside an enclosure.
Explosion can result.
IMPORTANT: DO NOT OVERFILL!
This equipment and/or its engine may include
evaporative emissions control system components,
required to meet EPA and/or CARB regulations, that
will only function properly when the fuel tank has
been filled to the recommended level. Overfilling
may cause permanent damage to evaporative
emissions control system components. Filling to the
recommended level ensures a vapor gap required to
allow for fuel expansion. Pay close attention while
lling the fuel tank to ensure that the recommended
fuel level inside the tank is not exceeded. Use a
portable gasoline container with an appropriately
sized dispensing spout when lling the tank. Do not
use a funnel or other device that obstructs the view
of the tank lling process.
DO NOT OVERFILL. Check engine oil level daily and
add as needed.
1. The engine must be off and allowed to cool at least two minutes
before adding fuel.
2. Remove the fuel ller cap and ll the tank. (See engine manual
for fuel capacity, fuel recommendation, and location of fuel cap.)
ADD GASOLINE TO ENGINE
2. Remove the oil ll cap/dipstick
to add oil.
CLOSEDOPEN
3. Replace the fuel cap and tighten. Always clean up spilled fuel.
If the engine is hot, closing the choke is not necessary.
STARTING ENGINE
2. Move the choke lever to the CLOSED position. (see Figure 9)
3. Move the throttle control lever slightly forward to about ¼ of
the way (Slightly toward the fast position). (see Figure 9)
ON OFF
Throttle Control Lever
Choke Control Lever
1. Move the engine switch to the
ON position.
ONOFF
13
YT5328PM02 - 1807
|
Operation