User`s manual

6.4 Homing/JOG Speed Table
6-25
6
Program Table
(2) Related Parameters
The homing/JOG speed table operation signal can be set with the following parameters.
Parameter Meaning When Enabled
PnB04
0
[Factory setting]
Starts homing when input signal is ON (close).
After restart
1 Starts homing when input signal is OFF (open).
2, 3 Does not start homing.
PnB05
0
[Factory setting]
Executes JOG operation in forward direction when input signal is ON
(close).
1
Executes JOG operation in forward direction when input signal is
OFF (open).
2, 3 Does not execute JOG operation.
PnB06
0
[Factory setting]
Executes JOG operation in reverse direction when input signal is ON
(close).
1
Executes JOG operation in reverse direction when input signal is
OFF (open).
2, 3 Does not execute JOG operation.
PnB11
0
[Factory setting]
Starts deceleration in homing when input signal is ON (close).
1 Starts deceleration in homing when input signal is OFF (open).
2 Sets homing limit switch always ON.
3 Sets homing limit switch OFF.
Parameter Signal Name Setting Factory Setting When Enabled
PnB07 /JOG0 0: When input signal is ON
(close), JOG speed table selec-
tion signal becomes active.
1: When input signal is OFF
(open), JOG speed table selec-
tion signal becomes active.
2: JOG speed table selection sig-
nal is always active.
3: JOG speed table selection sig-
nal is always inactive.
0 After restart
PnB08 /JOG1
PnB09 /JOG2
PnB0A /JOG3