User`s manual

7.7 Serial Commands
7-27
7
Serial Command Communications
LOOPTsss = nnnnn
Program Table LOOP Write
Sets the LOOP value (number of repetitions).
sss: Program step (PGMSTEP)
Setting:
1 ≤ nnnnn ≤ 99999
OK
NEXTTsss
Program Table NEXT Read
Reads the NEXT value (link destination).
sss: Program step (PGMSTEP)
NEXTT123 = 12345 [CR] [LF]
NEXTT123 = END [SP] [SP] [CR] [LF]
NEXTTsss = nnn
Program Table NEXT Write
Sets the NEXT value (link destination).
sss: Program step (PGMSTEP)
Settings:
0 ≤ nnn ≤ 255: Program step (PGMSTEP)
END: End
OK
Program Table Setup Commands (cont’d)
Serial Command Function/Description Positive Response