User`s manual

ManualsBrandsYASKAWA ManualsConsumer electronicsVarispeed G7

8 APPENDIX

39

8.1.2 Status Data (read only)

Command Code Description Drive

Read Write BIT Display F7 G7

Drive Status Yes Yes

0 1: During Run Yes Yes

1 1: Zero Speed Yes Yes

2 1: While in REV Yes Yes

3 1: Reset Signal During Input Yes Yes

4 1: During Speed Agree Yes Yes

5 1: Drive Ready Yes Yes

6 1: Alarm Yes Yes

7 1: Fault Yes Yes

8-D Not Used - -

E 1: Comref Status Yes Yes

1010H -

F 1: Comctrl Status Yes Yes

Operator Status Yes Yes

0 1: During OPE Yes Yes

1 Not Used - -

2 1: PRG mode Yes Yes

1011H -

3-F Not Used - -

1012H - Openo. Yes Yes

1013H - Drive Ccode F7 : 2020H G7: 2050H Yes Yes

Fault Description 1 Yes Yes

0 PUF Fuse Blown Yes Yes

1 UV1 Main Circuit Undervoltage / Main Circuit MC Operation Error Yes Yes

2 UV2 Control Power Supply Fault Yes Yes

3 UV3 Inrush Prevention Circuit Fault Yes Yes

4 - Not Used - -

5 GF Ground Yes Yes

6 OC Overcurrent Yes Yes

7 OV Main Circuit Overvoltage Yes Yes

8 OH Heat Sink Overheat Yes Yes

9 OH1 / Drive Internal Cooling Fan Stop Yes Yes

A OL1 Motor Overload Yes Yes

B OL2 Drive Overload Yes Yes

C OL3 Overtorque 1 Yes Yes

D OL4 Overtorque 2 Yes Yes

E RR Internal Braking Transistor Fault Yes Yes

1014H -

F RH Installed Braking Resistor Overheat Yes Yes

Fault Description 2

0 EF3 External Fault (Input Terminal S3) Yes Yes

1 EF4 External Fault (Input Terminal S4) Yes Yes

2 EF5 External Fault (Input Terminal S5) Yes Yes

3 EF6 External Fault (Input Terminal S6) Yes Yes

4 EF7 External Fault (Input Terminal S7) Yes Yes

5-6 - Not Used - -

7 OS Overspeed Yes Yes

8 DEV Excessive Speed Deviation Yes Yes

9 PGO PG Disconnect Detection Yes Yes

A PF Main Circuit Voltage Fault Yes Yes

B LF Output Phase Yes Yes

C OH3 Motor Overheat Alarm Yes Yes

D OPR Operator Connection Error Yes Yes

E ERR EEPROM Write Error Yes Yes

1015H -

F Oh4 Motor Overheat Fault Yes Yes