Instruction manual

6. Programming Features

Factory settings of the constants are shaded in the tables.

 Constant Setup and Initialization

 Constant Selection/Initialization (n001)

The following table lists the data that can be set or read when n001 is

set. By setting this constant, the fault history can be cleared and the con-

stants initialized. Unused constants between n001 and n179 are not dis-

played.

* 1. Excluding setting-disabled constants.

* 2. Refer to page 90.

n001 Setting Constant that can be Set Constant that can be Referenced

0 n001 n001 to n179

n001 to n049

n001 to n079

n001 to n119

n001 to n179

5 Not used

6 Fault history cleared

7 Not used

8 Initialize

Initialize (3-wire sequence)