User`s manual

Wiring Chapter 2-2

Wiring Method 1. Loosen the terminal screws with a thin-slotted screwdriver.

2. Insert the wires from underneath the terminal block.

3. Tighten each terminal screw firmly to a torque specified in the previous

tables.

Note 1. Always separate the control signal line from the main circuit cables and

other power cables.

2. Do not solder the wires to the control circuit terminals. The wires may not

contact well with the control circuit terminals if the wires are soldered.

3. The end of each wire connected to the control circuit terminals must be

stripped for approximately 5.5 mm.

4. Connect the shield wire to the ground terminal of the CIMR-J7AZ. Do not

connect the shield wire to the device side being controlled.

5. Be sure to insulate the shield wire with tape so that the shield wire will not

come into contact with other signal wires or equipment.

Applying excessive torque may damage

the terminal block. If the tightening torque

is insufficient, homever, wires may dis-

connect.

Note

Thin-slotted screwdriver

Terminal block

Solderless terminal or

wire without soldering.

Wire

Strip the end for approximately

5.5 mm if no solderless

terminal is used.