MVC Series- Installation Guide
Table Of Contents
- Contents
- Introduction
- Deployment and Connection
- Initial Setup
- Setting up Yealink MVC900/MVC800/MVC500/MVC300
- Basic Settings of Teams Room Systems
- Basic Features for Microsoft Teams Rooms App
- Switching Between Skype User Account And Administrator Account
- Logging into Yealink Management Cloud Service/Yealink Device Management Platform
- Troubleshooting
- Upgrading System Software
- Firmware for Each Device
- General Issues
- Does the MVC900/MVC500/MVC800/MVC300 Come with All the Necessary Software Pre-installed?
- The Room Is Not Enabled for Teams Meetings
- There Is No Content Displayed on the Second Display
- Why Can not Click Finish After Completing the Setup Wizard?
- Any Anti-virus Software Needed to Be Installed on the Mini-PC?
- Restarting the Device
- Checking the Status of Your Device
- Appendix
| Basic Settings of Teams Room Systems | 30
5.
Tap Finish to complete the setup wizard.
Basic Settings of Teams Room Systems
This section describes the following basic settings for the Teams Room Systems.
•
Controlling UVC80/UVC50/UVC30 Room Camera
•
Adjusting the Camera Layout of the MVC900 System
•
Single and Dual External Display
•
Content Sharing
•
Adjusting the MTouch Lightness
•
Changing Sign-in Account
Controlling UVC80/UVC50/UVC30 Room Camera
Microsoft Teams Rooms supports basic PTZ control for your UVC80/UVC50/UVC30 Room camera. In addition, you
can use the preset position feature if you set up preset positions for your camera connected to the MVC system on the
Yealink RoomConnect plug-in.
Note: The Yealink RoomConnect plug-in running under Windows supports advanced settings for UVC80/
UVC50/UVC30 cameras. After logging in to the Windows system as an administrator, you can configure
the camera parameters including exposure, graphic , white balance mode, people counting (not applicable to
MVC900 system), and configuration hangup mode and camera pan direction.
For more information on how to configure camera parameters on the Yealink RoomConnect plug-in, please
refer to Yealink RoomConnect User Guide.
•
Enabling/Disabling Auto-framing
•
Controlling Room Camera Position
•
Resetting Room Camera to Home Position
•
Creating the Preset Position on the Yealink RoomConnect Plug-in
•
Setting Camera to Preset Position
Enabling/Disabling Auto-framing
Auto-framing is mainly based on face detection, which provides real-time detection and position tracking on all faces
in the conference room. All participants in the output screen are covered and the camera can be automatically adjusted
according to the number of participants and the position changes.
About this task
When the auto-framing feature is enabled, you can not control the UVC30 camera, but you can control the UVC80/
UVC50 or use its preset position. After the UVC80/UVC50 is manually adjusted, the auto-framing feature is function
is temporarily turned off. If you need to use it again, you need to press the auto-framing key on the remote control to
turn it on.
Auto-framing is not applicable to MVC900 system.
Procedure
1.
Tap to enter the Camera Control page.
If you are in a meeting, tap > .