User Manual

Yealink Skype for Business HD IP Phones Administrator Guide
366
Parameter
Permitted Values
Default
WAN (Internet) port to the PC (LAN) port.
0-Disabled
1-Enabled
If it is set to 1 (Enabled), all data packets from WAN port can be received by PC port.
Note: It works only if the value of the parameter “network.pc_port.enable” is set to 1 (Auto
Negotiate). If you change this parameter, the Skype for Business phone will reboot to
make the change take effect.
Web User Interface:
Network->Advanced->Span to PC->Span to PC Port
Phone User Interface:
None
To enable span to pc port via web user interface:
1. Click on Network->Advanced.
2. Select Enabled from the pull-down list of Span to PC Port.
3. Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
4. Click OK to reboot the Skype for Business phone.
Then you can use Sniffer, Ethereal or Wireshark software to capture the signal traffic.