User Manual

Setting Up Your System
21
Setting Up Your System
This section describes essential information on how to set up your phone network and set up your
phones with a provisioning server. It also provides instructions on how to set up a provisioning
server, how to deploy Yealink phones from the provisioning server, how to upgrade firmware, and
how to keep user personalized settings after auto provisioning.
This chapter provides the following sections:
 Setting Up Your Phone Network
 Setting Up Your Phones with a Provisioning Server
Setting Up Your Phone Network
Yealink phones are operated on an Ethernet local area network (LAN). Local area network design
varies by organization and Yealink phones can be configured to accommodate a number of
network designs.
In order to get your phones running, you must perform basic network setup, such as IP address
and subnet mask configuration. You can configure the IPv4 or IPv6 network parameters for the
phone. You can also configure the appropriate security (VLAN and/or 802.1X authentication)
and Quality of Service (QoS) settings for the phone.
This chapter describes how to configure all the network parameters for phones, and it provides
the following sections:
This chapter describes how to configure all the network parameters for phones, and it provides
the following sections:
 DHCP
 DHCP Option
 Configuring Network Parameters Manually
 PPPoE
 Configuring Transmission Methods of the Internet Port and PC Port
 Configuring PC Port Mode
 Web Server Type
 VLAN
 IPv6 Support
 Quality of Service (QoS)
 802.1X Authentication
 Branch Office Resiliency