User Manual

Yealink Skype for Business HD IP Phones Administrator Guide
60
switch, the Skype for Business phones perform an update and reboot. This allows the Skype for
Business phones to be plugged into any switch, obtain their VLAN IDs, and then start
communications with the call control.
Procedure
CDP can be configured using the configuration files or locally.
Configuration File
<y0000000000xx>.cfg
Configure CDP.
Parameters:
network.cdp.enable
network.cdp.packet_interval
Local
Web User Interface
Configure CDP.
Navigate to:
http://<phoneIPAddress>/servlet?
p=network-adv&q=load
Phone User Interface
Configure CDP feature.
Details of Configuration Parameters:
Parameters
Permitted Values
Default
network.cdp.enable
0 or 1
1
Description:
Enables or disables the CDP (Cisco Discovery Protocol) feature on the Skype for Business
phone.
0-Disabled
1-Enabled
Note: If it is set to 1, the Skype for Business phone will attempt to determine its VLAN ID
through CDP. If you change this parameter, the Skype for Business phone will reboot to
make the change take effect.
Web User Interface:
Network->Advanced->CDP->Active
Phone User Interface:
Menu->Advanced (default password: admin) ->Network->CDP->CDP Status
network.cdp.packet_interval
Integer from 1 to 3600
60
Description:
Configures the interval (in seconds) for the Skype for Business phone to send the CDP