User Manual

Setting Up Your System
61
Parameters
Permitted Values
Default
(Cisco Discovery Protocol) request.
Note: It works only if the value of the parameter “network.cdp.enable” is set to 1 (Enabled).
If you change this parameter, the Skype for Business phone will reboot to make the change
take effect.
Web User Interface:
Network->Advanced->CDP->Packet Interval (1~3600s)
Phone User Interface:
Menu->Advanced (default password: admin) ->Network->CDP->Packet Interval
To configure CDP via web user interface:
1. Click on Network->Advanced.
2. In the CDP block, select the desired value from the pull-down list of Active.
3. Enter the desired time interval in the Packet Interval (1~3600s) field.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
5. Click OK to reboot the Skype for Business phone.
To configure CDP feature via phone user interface:
1. Press Menu->Advanced (default password: admin) ->Network->CDP->CDP Status.
2. Press or , or the Switch soft key to select the desired value from the CDP Status
field.