Owner`s manual

http://www.yowzafitness.com/
15
STEP2
ASSEMBLY
112
507
109
508
517
708
511
8
109
F
508507
D
705
704
112
708
511
109
708
511
109
C
STEP2-A). Remove the Undercarriage Cover (704, 705) by carefully lifting pedal
Assembly and removing each piece one at a time. Be careful not to snap
Plastic push pins when taking apart. Place Styrofoam block (8) under
Main Frame tube to provide clearance for positioning of Main Frame (112) for
Assembly. Verify that rear incline frame holder (206) is securely tightened
to Main Frame (112).
STEP2-B). Attach Incline Frame Set to the Main Frame, and hold the Incline Frame
Holder Front (708) to the Incline Frame (109), secure using Allen head
CAP Bolts (511) with Spring Washer (517) on the Incline Frame Holder.
Don’t fully tighten Allen Head CAP Bolt (511) until STEP2-D
STEP2-C). Rotate the Incline Frame (109) to align the bolt holes with the mating bolt
Holes in the Incline Transmission Tube-Front (110).
Assemble the Incline Transmission Tube-Front (110) to the Incline Frame
(109).
STEP2-D1). Firstly, tighten the Allen Head Bolt (507), and make sure again that
already fully was matched here.
STEP2-D2). Then fasten the Nylon Nut (508) by 8mm Allen Key (C) and Wrench (D).
Fully tighten the Allen Head Bolt (50) by 8mm Allen Key.
511
X4
517
X4
507
X1
508
X1
STEP2-A
STEP2-B
STEP2-C
STEP2-D