Owner`s manual

http://www.yowzafitness.com/

STEP2

ASSEMBLY

112112

705705

704

Step 2-A

708

109

511

Step 2-B

109

508507

Step 2-CD

708

517

511

Step 2

STEP2-A). Remove the Undercarriage Cover (704, 705) by carefully lifting pedal

Assembly and removing each piece one at a time. Be careful not to snap

Plastic push pins when taking apart. Verify that rear incline frame holder

(206) is securely tightened to Main Frame (112).

STEP2-B). Attach Incline Frame Set to the Main Frame, and hold the Incline Frame

Holder – Front (708) to the Incline Frame (109), secure using Allen head

CAP Bolts (511) with Spring Washer (517) on the Incline Frame Holder.

Don’t fully tighten Allen Head CAP Bolt (511) until STEP2-D

STEP2-C). Rotate the Incline Frame (109) to align the bolt holes with the mating bolt

Holes in the Incline Transmission Tube-Front (110).

Assemble the Incline Transmission Tube-Front (110) to the Incline Frame

(109).

STEP2-D1). Firstly, tighten the Allen Head Bolt (507), and make sure again that

already fully was matched here.

STEP2-D2). Then fasten the Nylon Nut (508) by 8mm Allen Key (D) and Wrench (F).

Fully tighten the Allen Head Bolt (511) by 8mm Allen Key.

511

517

507

508