Manual

Continuation Tests (Certain Tests Only)

1 Select ‘Follow-On’ and press [OK] while the result is displayed of the

currently running test. The photometer applies the previously entered

sample number and dilution factor, and the ‘Insert Sample’ screen will

appear.

Place SAMPLE tube in the test chamber, then press [OK].

2 The instrument will take the reading and calculate the result from the

combination of readings (where appropriate). The result will be displayed

as follows, for example:

3 While the test result is displayed, similar options are available as at the

end of a normal test program. In order to run more samples for the same

parameters, select ‘Return’ from the ‘options menu' to take the program

back to the start of the first stage of a multiple test procedure.

Note: some continuation test procedures involve a standing period. The

photometer may switch off automatically during this time. To avoid the

instrument switching off, set for continuous operation or use the timer

function to time any standing period. See Timer section. The timer will

over-ride the auto switch off function.

Favorite Tests List

The four most recently used tests are listed at the top of the 'Choose a Test'

screen for convenience.

Expressing Different Chemical Forms

If the test result can be expressed in different chemical forms, the chemical

symbol will have flashing  and  to indicate this. Use the  and  keys to

step through the options available.

Note that the log stores the result in the primary form.

Chlorine-Total / 5

Phot 008

1.50

mg/l Cl

Choose a Test Read Blank

Return