User manual

Problem Possible cause Solution
The door has been opened too fre-
quently
Do not leave the door open longer
than necessary
Food placed in the appliance was
too warm
Allow food to cool to room temperature
before storing
The temperature of the room that
contains the appliance is too high for
efficient operation
Try to reduce the temperature in the
room where the appliance stands
Water flows at the back plate
of the refrigerator
During automatic defrosting, frost
melts on the back plate
It is normal
Water flows into the refrigera-
tor compartment
The outlet can be clogged up Clean the outlet
Products placed in can prevent water
from flowing into the collector
Replace the products so that they can
not touch the back plate directly
Water flows onto the floor The melting water outlet flows not in-
to the evaporative tray above the
compressor
Put the melting water outlet to the
evaporative tray
The lamp does not work. The lamp is in stand-by. Close and open the door.
The lamp is defective. Refer to "Replacing the lamp".
It is too warm in the refrigera-
tor
The Temperature Regulator may be
set incorrectly
Set a lower temperature
The door does not close tightly or it
is not shut properly
Check if the door closes well and the
gasket is undamaged and clean
Food placed in the appliance was
too warm
Allow food to cool to room temperature
before storing
Large quantities of food to be cooled
were put in at the same time
Insert smaller quantities of food to be
cooled at any one time
There is no inside cool air circulation Provide inside cool air circulation
It is too cold in the refrigera-
tor
The Temperature Regulator may be
set incorrectly
Set a higher temperature
There is too much frost and
ice
Products are not wrapped properly Wrap the products better
Doors are not shut properly or do not
close tightly
Check if the doors close well and the
gaskets are undamaged and clean
The Temperature Regulator may be
set incorrectly
Set a warmer temperature
It is too warm in the freezer Temperature Regulator may be set
incorrectly
Set a lower temperature
The door does not close tightly or it
is not shut properly
Check if the door closes well and the
gasket is undamaged and clean
20