User manual

x
x
If necessary cut the adhe-
sive sealing strip and then
apply it to the appliance
as shown in figure.
1
2
44mm
The distance between the
lower part of the kitchen
furniture and the appli-
ance must be 44 mm.
Install the appliance in the
niche.
I
I
Attach the appliance to
the niche with 4 screws.
Remove the correct part
from the hinge cover (E).
B
E
E
C
D
Attach the covers (C, D) to
the lugs and the hinge
holes.
Install the vent grille (B).
Attach the hinge covers
(E) to the hinge.
Ha
Hb
Hc
Hd
Disconnect the parts Ha,
Hb, Hc and Hd
ca. 50 mm
ca. 50 mm
21 mm
90°
21 mm
90°
Install the part Ha on the
inner side of the kitchen
furniture.
Ha
Hc
Push the part Hc on the
part Ha.
Ha
Hb
8 mm
Open the appliance door
and the kitchen furniture
door at an angle of 90°.
Insert the small square
(Hb) into guide (Ha).
Put together the appliance
door and the furniture
door and mark the holes.
Ha
K
8 mm
Remove the brackets and
mark a distance of 8 mm
from the outer edge of the
door where the nail must
be fitted (K).
Hb
Place the small square on
the guide again and fix it
with the screws supplied.
Align the kitchen furniture
door and the kitchen furni-
ture door with the clear-
ance of the slots in the
part Hb.
Hb
Hd
Press the part Hd on the
part Hb.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic sealing strip is attached tightly to the
cabinet.
24