User Guide

※
The specifications of any product may change without prior notice to improve performance.
4
Clip Support Fixing Bolt
Socket Lever Hinge
Lever Slot
Lever Slot
Socket Lever
Clip Support for Socket 775
Motherboard
Backplate for Socket 775
Backplate Support
CPU (IHS)
Bolt
Grip (S-Type)
Grip (S-Type)
Clip Support for
Socket 775
Socket
775
478
754/939/940
Grip
S - Type
L - Type
L - Type
Hole
Hole
Inner Hole
Outer Hole
7. Installation
※ CNPS7700 must be used with a grip specific to
each CPU socket. Refer to the table on the
right to choose the correct grip for use.
1) Intel Pentium 4 - Socket 775
①①
Install Clip Support for Socket 775
Align the clip support for socket 775 and the backplate for socket 775 with the mounting holes on the motherboard
and fasten them together using the clip support fixing bolts. The lever slot on the clip support should be properly
oriented on the hinged side of the socket lever when installing.
* The backplate support is used for the convenience of installation. You can remove it if it is not deemed necessary.
②②
Apply Thermal Grease
Clean off particles and residue from the top of the
CPU then spread a generous amount of the included
thermal grease thoroughly on top of the CPU.
※ Unlike the flat-milled base of the FHS, the top surface of the LGA775 CPU may have minute dips and peaks
causing pockets of non-contact between the FHS and CPU. Please apply a generous amount of thermal grease
on the top of the CPU.
③③
Install Grips and Bolts
Interlock the S-type grips with the clip. Insert the two
bolts into the holes of the grips.
④④
Place FHS
Set the FHS at the center of the CPU. Screw the bolts
in slightly, then tighten each bolt a few turns at a time while
alternating between the two until the clip support is
completely pressed against the grips.
⑤⑤
Connect Power (How to use FAN MATE 2)
◆ Please refer to FAN MATE 2 Installation and Usage on page 7.