Operating instructions

27
For contractors
2.4 Instructions and regulations
 

 
intended for this equipment.
 
 
  (
A
13).
 



 
a room free from the risk of frost, as water residues remain inside the appliance.
 
 
Material of the cold water line:
Steel, copper or plastic pipework.
Material of the DHW line:
Copper or plastic pipework*.
* The instantaneous water heater can reach operating temperatures up to 85 °C. In case of faults, loads up
to 95 °C / 1.2 MPa can occur temporarily in the installation. Any plastic pipework used must be suitable for
these conditions.
 
 
 
 
 
 
 
disconnect all poles with at least 3 mm contact separation.