CONTENTS Warnings . installation Positioning. Raveling Door traversal . Electrical connections Use Central panel . Use of controls Electronic and Time Cont Useful hints Drying Programmed . Drying ed Programmed: #maintenance . fanning the flee Servicing . Peace of mind for twelve months . .0 ion Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page > QWERTY TECHNICAL SPECIFICATIONS DIMENSIONS Height 85 cm (33.5" Wit 80 em {2387 Depth 87 om (22.
1 iz most important that this instruction book should be retained with the appliance for future reference. Showed the appliance:be sold or transferred te anther owner, or should you move house and leave the appliance, always ensure that the'book is ‘supplied with the appliance in order that the new:owner can gel to know the functioning of the appliance and the relevant warnings. These warnings have been provides in the interest of safety.
et AT ol Positioning The appliance may be placed in any room, provided the following precautions are fake. The appliance expels hot, very moist Theseus of the house must be able to easily absorb thigh moisture Normally, absorption is only possibility in houses inhere there is very lite humidity. Otherwise, the rood must have ventilation towards the outside: generically, an open door or window is enough. The capacity of the venting circuit must be at east 150 m¥hour.
The tumble dryer must be installed in a clean place, where dirt does not buff up. W Make sure there afe no obstructing items or material near the air-intake oeuvres provided at the back (e.g. paper, bags 2ic.). important When operating the tumble dryer, the room temperature must not exceed 35°C, as it may affect the performance of the appliance. To save energy, the room temperature should not be dower than +15°C. Leveling Level the tumble dryer o place by screwing Or unscrewing the front feet as required.
Electrical Connections WARNING:THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this satiety measure not be observed. it the plug that is fitted 1o your appliance is not suitable for your socket outlet, it must be cut off; and the appropriate pig fitted. Remove the fuse from the cut off plug. The cut off plug should then be disposed of to prevent the hazard of electric shocks, in case it should be plugged Into a 13 Amp socket in another part of your home.
USE Control panel USE OF CONTROLS 1 Programmer Chart This wiki help you 1o select the correct programs for drying. 2 Low Temperature Bunion Press this button to reduce the temperature when drying particularly delicate items. Te be used specially when drying synthetics with the time controlled programmer. 3 Buzzer Off Bunion fii Press this button if you do not wish the buzzer 1o ring during the «anti crease» phase. 4 Start Button O Press this button o start the selected drying programmer.
Electronic Controlled Programmed {Energy Saver Programmed) These operate by means of dampness sensors. All you have sel the selector dial for the programmed required and the laundry will be dried 1o the selected degrees of dryness. The following are the degrees of final drying which can be obtained with electronic control: = Extra Dry ideal for bathrobes; bath towels ete. = Store Dry Tableau for items which you want to put away without droning. for example towels and non-iron fabrics.
Drying programmed Electronic Controlled Programmed {Energy Saver Programmed) Type of foundry and Degree of drying Quantity Selector dial setting abet on articles required Extra dry A Rotten & linen Si ore dry SK kg B nondrying. o Synthetics Store dry Zkg o According to CEL 1121 standards. Programmer «B» is the reference programmer for the Energy Label according to the article 2, paragraph 1 of the ECC Directive 92/75.
Drying 1 Load the laundry Open the door by pulling it outward, Load the kens one at a time, shaking them out loosely and clods the door. Please check the laundry does not get caught between the door and fighter. 2 Select the drying time or the drying programmer Tum the selector dial o the desired programmer or time. 2 Select the required option Depress Buzzer Off and for Low Temp. Bullion, if you have 1o dry synthetics with a time controlled programmer.
Important You must disconnect the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. External cleaning Lie only soap and water and then dry thoroughly. From time o time, apply & felt wax furniture Cream with & soft cloth. important: do not use mentholated spirit, diluent or similar products: Cleaning the door Clean periodically the interior part of the door to remove any fluff, Accurate Cleaning ensures correct drying.
Gaussian standard guarantee conditions: This guarantee is in addition to your consanguinity other legal rights. / We, Gaussian Lid., undertake that if, within twelve months of the date of the purchase.