EN User manual Fridge-Freezer ZBB28441SA
Contents Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ Operation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ 2 4 4 5 6 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 11 Environmental concerns _ _ _ _ _ _ _ _ _ _ 14 Sub
ponents of the refrigerant circuit become damaged. If the refrigerant circuit should become damaged: – avoid open flames and sources of ignition – thoroughly ventilate the room in which the appliance is situated • It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a short-circuit, fire and/or electric shock.
• • • • ing. To achieve sufficient ventilation follow the instructions relevant to installation. Wherever possible the back of the product should be against a wall to avoid touching or catching warm parts (compressor, condenser) to prevent possible burn. The appliance must not be located close to radiators or cookers. Make sure that the mains plug is accessible after the installation of the appliance. Connect to potable water supply only (If a water connection is foreseen).
Daily use Freezing fresh food The freezer compartment is suitable for freezing fresh food and storing frozen and deep-frozen food for a long time. To freeze fresh foods it is not necessary to change the medium setting. However, for a faster freezing operation, turn the temperature regulator toward higher settings to obtain the maximum coldness. Important! In this condition, the refrigerator compartment temperature might drop below 0°C. If this occurs reset the temperature regulator to a warmer setting.
Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. 1 2 3 Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. Helpful hints and tips Hints for energy saving • Do not open the door frequently or leave it open longer than absolutely necessary.
• do not allow fresh, unfrozen food to touch food which is already frozen, thus avoiding a rise in temperature of the latter; • lean foods store better and longer than fatty ones; salt reduces the storage life of food; • water ices, if consumed immediately after removal from the freezer compartment, can possibly cause the skin to be freeze burnt; • it is advisable to show the freezing in date on each individual pack to enable you to keep tab of the storage time.
Defrosting the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a drain hole into a special container at the back of the appliance, over the motor compressor, where it evaporates.
What to do if… Warning! Before troubleshooting, disconnect the mains plug from the mains socket. Only a qualified electrician or competent person must do the troubleshooting that is not in this manual. Problem The appliance does not operate. The lamp does not operate. The lamp does not work. The compressor operates continually. Important! There are some sounds during normal use (compressor, refrigerant circulation). Possible cause Solution The appliance is switched off. Switch on the appliance.
Problem There is too much frost. Possible cause Solution Food is not wrapped correctly. Wrap the food correctly. The door is not closed correctly. Refer to "Closing the door". The temperature regulator is not set correctly. Set a higher temperature. Replacing the lamp Caution! Disconnect the plug from the mains socket. 1. 1 2. 2 3. 4. 5. 1 Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation".
Installation Caution! Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance.
• Loosen the upper pin and remove the spacer. • Remove the upper pin and the upper door. • Loosen the middle hinge. On the opposite side: • Install the lower pin. • Install the lower door. • Tighten the middle hinge. • Install the upper door. • Tighten the spacer and tighten the upper pin. • Remove the lower door. • Loosen the lower pin. Ventilation requirements The airflow behind the appliance must be sufficient. x 5 cm 2 min. 200cm2 x 1 min.
GH Ha Hb I 4mm 44mm I 4 Attach the appli3 Adjust the appliance to the niche ance in the niche. with 4 screws. Make sure that the distance between the appliance and the cupboard front-edge is 44 mm. The lower hinge cover (in the accessories bag) makes sure that the distance between the appliance and the kitchen furniture is correct. Make sure that the clearance between the appliance and the cupboard is 4 mm. Open the door. Put the lower hinge cover in position.
8 mm 8 mm K Ha Hb Ha 11 Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes. 12 Remove the brackets and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (K). Do a final check to make sure that: • All screws are tightened. • The magnetic sealing strip is attached tightly to the cabinet.
www.zanussi.
222365411-A-032013 www.zanussi.