User manual

x
x
1
If necessary cut the
adhesive sealing strip and
then apply it to the appli-
ance as shown in figure.
1
2
2
Install the appliance in
the niche.
Push the appliance in the
direction of the arrows (1)
until the upper gap cover
stops against the kitchen
furniture.
Push the appliance in the
direction of the arrows (2)
against the cupboard on
the opposite side of the
hinge.
44mm
4mm
3
Adjust the appliance
in the niche.
Make sure that the dis-
tance between the appli-
ance and the cupboard
front-edge is 44 mm.
The lower hinge cover (in
the accessories bag)
makes sure that the dis-
tance between the appli-
ance and the kitchen fur-
niture is correct.
Open the door. Put the
lower hinge cover in posi-
tion.
I
I
4
Attach the appliance to
the niche with 4 screws.
5
Remove the correct
part from the hinge cover
(E). Make sure to remove
the part DX, in the case of
right hinge, SX in oppo-
site case.
E
E
D
C
B
6
Attach the covers (C,
D) to the lugs and the
hinge holes.
Install the vent grille (B).
Attach the hinge covers (E)
to the hinge.
G
H
Connect the appliance lat-
erally to the kitchen furni-
ture sidewall:
7
Loosen the screws of
the part (G) and move the
part (G) till the furniture
sidewall.
Tighten the screws of the
part (G) again.
Attach the part (H) to the
part (G).
Ha Hb
HdHc
8
Disconnect the parts
(Ha), (Hb), (Hc) and (Hd).
21 mm
21 mm
~50 mm
~50 mm
90
o
90
o
9
Install the part (Ha) on
the inner side of the kitch-
en furniture.
Ha
Hc
10
Push the part (Hc) on
the part (Ha).
23