User manual

• Be very careful when you replace the
pan supports to prevent the hob top
from damage.
After cleaning, dry the appliance with a soft
cloth.
Removing the dirt:
1. – Remove immediately: melting plastic,
plastic foil, and food containing sugar.
– Stop the appliance and let it cool
down before you clean: limescale rings,
water rings, fat stains, shiny metallic dis-
colorations. Use a special cleaner appli-
cable for surface of hob.
2. Clean the appliance with a damp cloth and
some detergent.
3. At the end rub the appliance dry with a
clean cloth.
The stainless steel can become tarnished if it is
too much heated. Refer to this you must not
cook with potstones, earthenware pans or cast
iron plates.
Cleaning of the spark plug
This feature is obtained through a ceramic igni-
tion candle with a metal electrode. Keep these
components well clean to prevent difficult light-
ing and check that the burner crown holes are
not obstructed.
Periodic maintenance
Periodically speak your local Service Force
Centre to check the conditions of the gas sup-
ply pipe and the pressure adjuster, if fitted.
Troubleshooting
Problem Possible cause Remedy
There is no spark when lighting the
gas
• There is no electrical supply • Make sure that the unit is con-
nected and the electrical supply
is switched on.
• Control the fuse. If the fuse is
released more than one time, re-
fer to a qualified electrician.
• Burner cap and crown are
placed uneven
• Make sure that the burner cap
and crown are in correct posi-
tions.
The flame is blow out immediately
after ignition
• Thermocouple is not heated suf-
ficient
• After lightning the flame, keep
the knob pushed for equal or
less than 10 seconds.
The gas ring burns unevenly • Burner crown is blocked with
food residues
• Make sure that the injector is
not blocked and the burner
crown is clear of food particles.
If there is a fault, first try to find a solution to the
problem yourself. If you cannot find a solution to
the problem yourself, speak your dealer or the
local Service Force Centre.
If you operated the appliance incorrectly, or
the installation was not carried out by a
registered engineer, the visit from the customer
service technician or dealer may not take place
free of charge, even during the warranty period.
8
www.zanussi.com