FRIGORIFEROCONGELATORE FRIDGE-FREEZER KÜHLGEFRIERSCHRANK REFRIGERATEURCONGELATEUR ZR 220/2 TNR LIBRETTO ISTRUZIONI INSTRUCTION BOOKLET BEDIENUNGSANLEITUNG MODE D’EMPLOI 2222 255-06
WARNINGS GB It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety.
CONTENTS Installation 13 ■ Positioning 13 ■ Cleaning the interior 13 ■ Instructions for totally built-in appliances 14 Electrical connection 16 ■ Technical specification 16 Use 17 ■ Operation ■ ■ Temperature regulation Freezing fresh food ■ Storage of frozen food GB ■ Thawing ■ Fresh food refrigeration ■ Defrosting 18 18 19 Maintenance ■ Periodic cleaning ■ Periods of non use ■ Replacing the interior light bulb Defective operation 20 20 20 20 17 17 18 17 INSTALLATION
I nstructions for totally built-in appliances Door reversibility (Fig. 1) P P 1 2 3 P1 P1 D607 Right opening Left opening Remove the pins (A) and (B) Remove (A) and (C) from both sides and the door. Remove the middle hinge (2) and refit it on the opposite side. Refit the door and (A) on the left side. Remove (D) from the right side.
Fig. 4 Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. D C D728 Fig. 5 D724 Press in the joint covers between the appliance and the kitchen unit. Fig. 6 B D726 Apply covers (B) on joint cover lugs and into hinge holes. Fig.
Open both the appliance door and that of the kitchen unit to approx. 90°. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 8 8mm PR34 Remove the little plates and make the holes with a diam. of 2 mm. Replace the little platee over the runners and screw in the screws provided (3.5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes.
USE Operation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. The appliance will start to operate. Temperature regulation The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings.
It is also advisable not to exceed the storage period indicated by the producer of the food. Finally, do not open the door frequently or leave it open longer than is absolutely necessary. If there is a power failure when food is in the freezer, do not open the door of the freezing compartment.
Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside.
MAINTENANCE Unplug the appliance before carrying out any maintenance operation. GB Interior light The light bulb inside the refrigerator compartment can be reached as follows: Internal clearing Never use metal objects for clearing your appliance as it may get damaged. When performing a complete defrosting, wash the internal surfaces of the freezer with lukewarm water and bicarbonate; rinse and then accurately dry.