FRIGORIFEROCONGELATORE FRIDGE-FREEZER KÜHL-GEFRIERSCHRANK REFRIGERATEURCONGELATEUR ZR 230/2 TN LIBRETTO ISTRUZIONI 2222 028-83 INSTRUCTION BOOKLET GEBRAUCHSANWEISUNG MODE D’EMPLOI
WARNINGS GB It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety.
CONTENTS Installation 16 ª Cleaning the interior 16 ª Instructions for building in 17 GB ª Building in and securing into a tall kitchen unit 18 ª Door opening device 19 ª Electrical connection 19 Technical specification 19 Use 20 ª Operation 20 ª Temperature regulation 20 ª Fresh food refrigeration 20 ª Movable shelves 21 ª Positioning the door shelves 21 ª Freezing fresh food 22 ª Storage of frozen food 22 ª Thawing 22 ª Ice-cube production 22 ª Defrosting 23 Maintenance
INSTALLATION If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. Positioning The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc.
Instructions for building in Fig. 1 Before building in the appliance reverse the opening direction of the doors (if necessary) as follows: Unscrew the top hinge (Fig. 1) which will later be refitted on the opposite side. The fixing holes are masked with covers which should be removed and fitted into the holes left open. D120 Unscrew the bottom hinge (A-Fig. 2) which will later be refitted on the opposite side. Fig. 2 A D119 Fig. 3 Remove the doors from the appliance and remove the centre hinge (Fig.
Building in and securing into a tall kitchen unit Fig. 4 50 8 Recess dimensions: Height Depth Width 1446 mm 550 mm 560 mm Ventilation is provided through the appliance grille and through an opening to be cut in the base of the unit (minimum size 200 cm2 - Fig. 4). 2 200 cm 25 D296 A vent outlet, 50 mm deep by 540 mm wide (Figs. 4 and 5) must be cut in the top of the unit. Fig. 5 50 540 Fit the bar section supplied to the top of the unit.
Door opening device (Fig. 8-9) Fig. 8 The appliance is supplied with an accessories pack which contains a device to allow the unit and appliance doors to be opened simultaneously. The device consists of guide (A), blocks (B), securing screws and block covers (C). To fix guide (A), drill the door as shown in Fig. 6. C A B Fit blocks (B) as follows: open the appliance door and the unit door to about 90°; position block (B) on the inside of the unit as shown in Fig. 8.
USE Operation Fresh food refrigeration Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. The appliance will start to operate. To obtain the best performance: Temperature regulation GB do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. Position food so that air can circulate freely round it.
Movable shelves Fig. 11 The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. D040 Fig. 12 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes off, then reposition as required.
Freezing fresh food Storage of frozen food The 4-star compartment ( ) is suitable for long term storage of commercially frozen food and for freezing fresh food. When first starting-up or after a period out of use, before putting the products in the compartment let the appliance run for at least two hours on the coldest setting, then turn the thermostat knob to the normal operating position.
Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container on the back of the appliance where it evaporates. Clean periodically the water discharge hole in the centre of the drip collector. Use the special cleaner provided, which you will find already inserted into the discharge hole.
MAINTENANCE Prior to undertaking any maintenance operation, be sure to unplug the appliance from the wall socket as a safety precaution. Clean the interior periodically with lukewarm water and some bicarbonate of soda; the cabinet exterior with a Silicone wax spray; the condenser and the motor compressor with a brush or a vacuum cleaner. GB Interior light The light bulb inside the refrigerator compartment can be reached as follows: - unscrew the light cover securing screw.
