EN User manual Fridge Freezer ZRB939NX2 ZRB939NW2
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 4 5 7 7 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Troubleshooting _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2. • • • • Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5. If the power plug socket is loose, do not insert the power plug. There is a risk of electric shock or fire. 6. You must not operate the appliance without the lamp cover (if foreseen) of interior lighting. This appliance is heavy.
Environment Protection insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the are recyclable. symbol This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials.
Control panel A B C D E A - Appliance button ON/OFF D - Function button B - Temperature regulation button E - Confirmation button C - Temperature and function indicator Display 10 9 8 1 7 2 6 3 4 5 1 Temperature indicator. 6 Timer function indicator. 2 Excessive temperature alarm. 7 Positive or negative temperature indicator. 3 FreeStore function indicator. 8 Action Freeze function indicator. 4 Shopping function indicator. 9 Compartment indicator.
If there is no confirmation after some seconds the display will go out from the menu and return in normal condition. The following functions are indicated: Select the fridge compartment Select the freezer compartment Eco Mode function FreeStore function Shopping function Child Lock function Drinks Chill function Action Freeze function Temperature regulation Press the key (D) to select the compartment and than the key (B) to set the necessary temperature. Press the key (E) to confirm the selection.
To freeze fresh foods, you will need to activate the Action Freeze function. Press key (D) (several times if necessary) indicator appears. until You must confirm the choice by pressing key (E) within few seconds. You will hear the buzzer and on the display will appear some animation with lines. After a pre-cooling period of 24 hours, place the foods in the freezer. compartment, as this Place the food to be frozen in the is the coldest point. The freezing process takes 24 hours.
Storage of frozen food Bottle rack When first starting-up or after a period out of use, before putting the products in the compartment let the appliance run at least 2 hours on the higher settings. Place the bottles (with the opening facing front) in the pre-positioned shelf.
Helpful hints and tips Normal Operating Sounds • You may hear a faint gurgling and a bubbling sound when the refrigerant is pumped through the coils or tubing. This is correct. • When the compressor is on, the refrigerant is being pumped around and you will hear a whirring sound and a pulsating noise from the compressor. This is correct. • The thermic dilatation might cause a sudden cracking noise. It is natural, not dangerous physical phenomenon. This is correct.
Care and cleaning Caution! Unplug the appliance before carrying out any maintenance operation. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Periodic cleaning The equipment has to be cleaned regularly: • clean the inside and accessories with lukewarm water and some neutral soap. • regularly check the door seals and wipe clean to ensure they are clean and free from debris. • rinse and dry thoroughly.
Problem Possible cause The compressor operates continually. The Temperature regulator may be set incorrectly. Set a warmer temperature. The door is not closed correctly. Refer to "Closing the door". The door has been opened too frequently. Do not keep the door open longer than necessary. The product temperature is too high. Let the product temperature decrease to room temperature before storage. The room temperature is too high. Decrease the room temperature.
Problem The lamp does not work. Possible cause Solution The lamp is in stand-by. Close and open the door. The lamp is defective. Refer to "Replacing the lamp". As much as the advice does not lead to result, call the nearest brand-mark service. Replacing the lamp 1. 2. 3. 4. 5. 6. 7. Disconnect the appliance. Push the movable part to unhook the lamp cover (1). Remove the lamp cover (2). If needed replace the lamp with a light of similar characteristic and power.
Climate class Ambient temperature SN +10°C to + 32°C N +16°C to + 32°C ST +16°C to + 38°C T +16°C to + 43°C 4. Tighten again the screws. 2 Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet.
A 2. B C D E Important! The wires in the mains lead are coloured in accordance with the following code: A Green and Yellow: Earth C Brown: Live D Blue: Neutral E B F C D 14 B Warning! A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that it is disposed of safely. Door reversibility Warning! Before carrying out any operations, remove the plug from the power socket.
• Open the doors. Unscrew the middle hinge (B). Remove the plastic spacer (A). • Remove the spacer (F) and move to the other side of the hinge pivot (E). • Remove the doors. • Remove the left-hand cover pin of the middle hinge (C,D) and move to the other side. • Fit the pin of the middle hinge (C) into the lefthand hole of the lower door. • Unscrew the lower hinge • Remove the plugs (1)on (A) the upper side of both doors and move them to • Remove the left-hand the other side.
210622262-A-012012 www.zanussi.
