Operation Manual

12
Buzzer
When the drying cycle
has finished, an inter-
mittent audible signal
will sound.
By depressing this
button the acoustic
signal is switched off
in the following cases:
• when selecting
the programme
• when depressing
the buttons
• when the pro-
gramme selector
dial is turned to
another position
during the pro-
gramme or when
you depress an
option button dur-
ing the cycle
• at the end of the
programme.
The corresponding
light comes on.
Start/Pause
Press this button to
start the dryer after
having selected the
programme and the
options. The relevant
light will stop flashing.
If the programme
selector dial is turned
to another position,
when the machine is
running, the buzzer
will sound and the
programme phase
indicator lights will
flash. The drum turns
alternately in both
directions during dry-
ing.
All drying pro-
grammes end with a
10 minute cooling
phase (light Cooling is
on). You may remove
the laundry after this
phase.
and illuminate
and the buzzer
sounds.
If the door of the
appliance or the small
door at the bottom is
opened while the pro-
gramme is running,
this button must be
pressed again after
closing the door in
order to restart the
programme from the
point at which it was
interrupted. This but-
ton must be
depressed also after a
power failure and
after having reinserted
the water reservoir, if
it has been emptied in
the middle of a pro-
gramme after lighting
up of light .
In both cases the light
of the Start/Pause
button flashes to
remind you that the
start button needs to
be pressed again.
Delay Start
This button allows you
to delay the starting of
the programme by 3,
6 or 9 hours.
Press the button until
the light relevant to
the desired delay
lights up. This option
must be selected after
having selected the
programme and
before 3 6 9 pressing
START/PAUSE to
start the programme.
The machine begins
the countdown, which
is shown by the pilot
lights. For example, if
you have chosen a 9-
hour delay (pilot light
9h lit), after 3 hours,
9h goes out and 6h
lights up; after 3 more
hours, 6h goes out
and 3h lights up.
When the 9 hours are
over (pilot light 3h off),
the drying cycle
begins. During the
delayed start period, it
is not possible to
change the pro-
gramme or the select-
ed delay. If you wish
to do so, you must
first cancel everything
by rotating the pro-
gramme selector dial
to position “O”.
Select the new pro-
gramme, the options
and the delayed start,
then press
START/PAUSE . If
you wish to change
only the options, this
can be done on condi-
tion that the new
option(s) is(are) com-
patible with the pro-
gramme. Set the
machine to PAUSE by
depressing the rele-
vant button, select the
new option(s) and
depress
START/PAUSE button
again.
If you wish to add
some laundry while
the machine is per-
forming the count-
down, after having
125987722_EN.qxp 2007-11-21 16:20 Page 12