User manual

Page - 30/89 AE9ZP0BD - DUALAC2/&HP/POWER - User Manual
C33 PPOT Traction potentiometer positive, 5/10 V output; use
load > 1 kohm.
C34 NTHERM_L Negative of left traction motor temperature sensor.
C35 PTHERM_L Left traction motor temperature signal.
D1 -BATT Negative output.
D2 2ND Second hydraulic speed input, active high.
D3 1ST First hydraulic speed input, active high.
D4 ENABLE Input for proportional lifting enable; active high.
D5 CMM Common output of microswitches (+BATT).
D6 5TH Fifth hydraulic speed input, active high.
D7 4TH Fourth hydraulic speed input, active high.
D8 3RD Third hydraulic speed input, active high.
D9 CPOTLIFT Input for proportional lift potentiometer.
D10 -BATT
D11 -BATT
D12 -BATT
D13 NPOTLIFT Negative for proportional lift potentiometer.
D14 PPOTLIFT Positive for proportional lift potentiometer (12 V).
6.3 CANBUS connector description
Dualac2 Controller has a canbus interface, so it has been designed to work
in a can network together with other electronic modules, exchanging
information over the canbus network.
Furthermore, the exchange of information between master and slave
microcontrollers is based on the canbus, as well.
Dualac2 also provides built-in can termination resistance, which can be
connected in different ways, as described here following:
6.3.1 "Dualac2" Controller in stand-alone configuration
Bridge 2-4 and 5-7 connect both built-in120 ohm can termination resistances.