User manual

Page - 50/89 AE9ZP0BD - DUALAC2/&HP/POWER - User Manual
8) SET TEMPERATURE
- DIGITAL: a digital (ON/OFF) motor thermal sensor is connected to C25
(C35) input.
- ANALOG: an analog motor thermal sensor is connected to C25 (C35)
(the curve can be customized on a customer request).
- NONE: no motor thermal sensor switch is connected.
9) STEER TABLE
This parameter is used to set the correct steering table.
10) CNC#8 INPUT USE
- OPTION #1: input C8 is used as enable input for the traction
request, active high (closed switch).
- OPTION #2: input C8 activates backing function, active high (closed
switch).
- NONE: input C8 isn’t used.
11) SMART DISPLAY
- ON / OFF: if this option is programmed ON the communication with the
Smart display is active.
SUBMENU "ADJUSTMENTS"
1) SET POT BRK MIN
It records the minimum value of braking pedal potentiometer when the
braking pedal switch is closed; the procedure is similar to the "Program Vacc"
function (see chapter 9.3). This procedure must be carried out only if the
"Pedal braking" option is programmed as "Analog".
2) SET POT BRK MAX
It records the maximum value of braking pedal potentiometer when the
braking pedal is fully pressed; the procedure is similar to the "Program Vacc"
function (see chapter 9.3). This procedure must be carried out only if the
"Pedal braking" option is programmed as "Analog".
3) SET BATTERY TYPE
It selects the nominal battery voltage.
4) ADJUST BATTERY
Fine adjustment of the battery voltage measured by the controller.
5) MAX STEER RIGHT
This is the function to record in the controller EEPROM the steering poti
output voltage when the wheels are fully turned right (maximum of the
steering poti range).
6) MAX STEER LEFT
This is the function to record in the controller EEPROM the steering poti
output voltage when the wheels are fully turned left (minimum of the steering
poti range).
7) SET STEER 0-POS.
This is the function to record in the controller EEPROM the steering poti
output voltage when the wheels are straight.
8) SET STEER RIGHT
This parameter sets the max steering angle in right direction.
9) SET STEER LEFT
This parameter sets the max steering angle in left direction.
10) THROTTLE 0 ZONE
It establishes a deadband in the accelerator input curve (see also curve
below).
11) THROTTLE X POINT
This parameter changes the characteristic of the accelerator input curve.
12) THROTTLE Y POINT
This parameter changes the characteristic of the accelerator input curve.