User manual

ManualsBrandsZapi ManualsConsumer electronicsAC-2

Page - 52/89 AE9ZP0BD - DUALAC2/&HP/POWER - User Manual

- OPTION #3: Equal to OPTION#2 but the truck definitively stops after 380

hours.

8.4.2 "Dualac2" and "Dualac2 Power" - Slave

Using the config menu of the programming console, the user can configure the

following functions.

SUBMENU "SET OPTIONS"

1) CNC#8 INPUT USE

- OPTION #1: input C8 is used as enable input for the traction

request, active high (closed switch).

- OPTION #2: input C8 activates backing function, active high (closed

switch).

- NONE: input C8 isn’t used.

SUBMENU "ADJUSTMENTS"

1) SET BATTERY TYPE

It selects the nominal battery voltage.

2) ADJUST BATTERY

Fine adjustment of the battery voltage measured by the controller.

3) AUX OUTPUT VOLTAGE

This parameter adjusts the voltage of the auxiliary output coil (hydraulic

steering contactor coil), PWM output C31.

8.4.3 "Dualac2&hp" and "Dualac2&hp Power" - Master

There are the same functions described in chapter 8.4.1, but in the “SET

OPTIONS” SUBMENU there is also the following parameter.

1) LIFT CUTOUT

- ON / OFF: when the “Battery low” alarm appears, if this option is

programmed ON the lifting is stopped.

8.4.4 "Dualac2&hp" and "Dualac2&hp Power" - Slave

Using the config menu of the programming console, the user can configure the

following functions.

SUBMENU "SET OPTIONS"

1) CNC#8 INPUT USE

- OPTION #1: input C8 is used as enable input for the traction

request, active high (closed switch).

- OPTION #2: input C8 activates backing function, active high (closed

switch).

- NONE: input C8 isn’t used.

SUBMENU "ADJUSTMENTS"

1) SET BATTERY TYPE

It selects the nominal battery voltage.

2) ADJUST BATTERY

Fine adjustment of the battery voltage measured by the controller.

3) SET ACCELER. MIN

This parameter is used to adjust minimum value of the lift potentiometer.

Press ENTER, pull the lever till the lift switch closes, then record the value

(OUT --> ENTER).

4) SET ACCELER. MAX

This parameter is used to adjust maximum value of the lift potentiometer.

Press ENTER, pull the lever to the maximum, then record the value (OUT -->