User manual

AE9ZP0BD - DUALAC2/&HP/POWER - User Manual Page - 63/89
The following table shows all the values of parameters.
PROGRAMMED LEVEL
PARAMETER UNIT
0 1 2 3 4 5 6 7 8 9
SPEED LIMIT % 0 - 100
PUMP IMAX %IMAX 50 55 61 66 72 77 83 88 94 100
PUMP ACCELER DELAY (*) Sec. 0.2 0.4 0.6 0.8 1 1.5 2 2.5 3 3.5
PUMP DECELER DELAY (**) Sec. 0.2 0.4 0.6 0.8 1 1.5 2 2.5 3 3.5
CREEP SPEED % 0 - 100
COMPENSATION % 0 - 100
1ST SPEED FINE % 0 - 100
1ST SPEED COMP. % 0 - 100
2ND SPEED FINE % 0 - 100
2ND SPEED COMP. % 0 - 100
3RD SPEED FINE % 0 - 100
3RD SPEED COMP. % 0 - 100
4TH SPEED FINE % 0 - 100
4TH SPEED COMP. % 0 - 100
5TH SPEED FINE % 0 - 100
5TH SPEED COMP. % 0 - 100
HYDRO SPEED FINE % 0 - 100
HYDRO COMPENS. % 0 - 100
HYDRO TIME Sec. 0 – 25.5
(*) The acceleration time shown is the theoretical time to change from 0V to
full voltage applied to the motor. This is an ideal ramp, the real ramp can
change as a function of the load.
(**) The deceleration feature is based upon deceleration ramps. The value
shown in the table is the time to decrease the voltage applied to the
motor from 100% down to 0%.